UM5075_14 Datasheet, PDF (4/8 Pages) Union Semiconductor, Inc. – Single Line ESD Protection Diode Array

UM5075/5079
Applications Information
Device Connection Options
UM5075/5079 ESD protection diode is designed to protect one data, I/O, or power supply line.
The device is unidirectional and may be used on lines where the signal polarity is above ground.
The cathode band should be placed towards the line that is to be protected.
Circuit Board Layout Recommendations for Suppression of ESD
Good circuit board layout is critical for the suppression of ESD induced transients. The following
guidelines are recommended:
1. Place the TVS near the input terminals or connectors to restrict transient coupling.
2. Minimize the path length between the TVS and the protected line.
3. Minimize all conductive loops including power and ground loops.
4. The ESD transient return path to ground should be kept as short as possible.
5. Never run critical signals near board edges.
6. Use ground planes whenever possible. For multilayer printed-circuit boards, use ground
vias.
7. Keep parallel signal paths to a minimum.
8. Avoid running protection conductors in parallel with unprotected conductor.
9. Minimize all printed-circuit board conductive loops including power and ground loops.
10. Avoid using shared transient return paths to a common ground point.
________________________________________________________________________
http://www.union-ic.com Rev.02 Dec.2014
4/8