CHA2394 Datasheet, PDF (6/8 Pages) United Monolithic Semiconductors – 36-40GHz Very Low Noise High Gain Amplifier

CHA2394
36-40GHz Very Low Noise Amplifier
Typical Bias Tuning for Low Noise Operation
The circuit schematic is given below :
Vd
100
100
50
IN
OUT
Vg 1,2
Vg 3
For low noise operation, a separate access to the gate voltages of the two first stages ( Vgs1&2 ), and
of the output stage ( Vgs3 ) is provided.
Nominal bias for low noise operation is obtained for a typical current of 20 mA for the output stage and
15 mA for each of the two first stages ( 50 mA for the amplifier ).
The first step to bias the amplifier is to tune the Vgs1&2 = -1V, and Vgs3 to drive 20 mA for the full
amplifier. Then Vgs1&2 is reduced to obtain 50 mA of current through the amplifier.
A fine tuning of the noise figure may be obtained by modifying the Vgs1&2 bias voltage, but keeping
the previous value for Vgs3.
Ref. : DSCHA23942240 -28-Aug.-02
6/8
Specifications subject to change without notice
Route Départementale 128 , B.P.46 - 91401 ORSAY Cedex - FRANCE
Tel.: [phone] - Fax : [phone]