TS128MDOM40V-S Datasheet, PDF (10/34 Pages) Transcend Information. Inc. – 40-Pin IDE Flash Module

TTrraannsscceenndd 4400--PPiinn IIDDEE FFllaasshh MMoodduullee
TTSS112288MM ~~ 1166GGDDOOMM4400VV--SS
Ultra DMA Mode Read/Write Timing Specification
Ultra DMA is an optional data transfer protocol used with the READ DMA, and WRITE DMA,
commands. When this protocol is enabled, the Ultra DMA protocol shall be used instead of the Multiword
DMA protocol when these commands are issued by the host. This protocol applies to the Ultra DMA data
burst only. When this protocol is used there are no changes to other elements of the ATA protocol.
UDMA Signal
DMARQ
DMACK
STOP
HDMARDY(R)
HSTROBE(W)
DDMARDY(W)
DSTROBE(R)
DATA
ADDRESS
CSEL
INTRQ
Card Select
Type
Output
Input
Input
Input
Output
Bidir
Input
input
Output
Input
TRUE IDE MODE
UDMA
DMARQ
-DMACK
STOP¹
-HDMARDY^1,2
HSTROBE(W)^1,3,4
-DDMARDY(W)^1,3
DSTROBE(R)^1,2,4
D[15:00]
A[02:00]⁵
-CSEL
INTRQ
-CS0
-CS1
Notes: 1) The UDMA interpretation of this signal is valid only during an Ultra DMA data burst.
2) The UDMA interpretation of this signal is valid only during and Ultra DMA data burst during a DMA Read command.
3) The UDMA interpretation of this signal is valid only during an Ultra DMA data burst during a DMA Write command.
4) The HSTROBE and DSTROBE signals are active on both the rising and the falling edge.
5) Address lines 03 through 10 are not used in True IDE mode.
Several signal lines are redefined to provide different functions during an Ultra DMA data burst.
These lines assume their UDMA definitions when:
1. an Ultra DMA mode is selected, and
2. a host issues a READ DMA, or a WRITE DMA command requiring data transfer, and
3. the device asserts (-)DMARQ, and
4. the host asserts (-)DMACK.
These signal lines revert back to the definitions used for non-Ultra DMA transfers upon the negation
of -DMACK by the host at the termination of an Ultra DMA data burst.
With the Ultra DMA protocol, the STROBE signal that latches data from D[15:00] is generated by the
Transcend Information Inc.
10
Ver 1.2