TLP2116 Datasheet, PDF (2/6 Pages) Toshiba Semiconductor – PHOTOCOUPLER GaAℓAs Ired & PHOTO-IC

TLP2116
Absolute Maximum Ratings (Ta=25°C)
Characteristic
Symbol
Forward current
(Each Channel)
Forward current derating
(Ta ≥ 85°C) (Each Channel)
Peak transient forward current (Each Channel) (Note 2)
Reverse voltage
(Each Channel)
Output current
(Each Channel)
Output voltage
(Each Channel)
Supply voltage
Output power dissipation
Operating temperature range
Storage temperature range
Lead solder temperature
(10 s)
Isolation voltage (AC,1min., R.H. ≤ 60%, Ta=25℃)
(Note 2)
I_F
⊿I_F/⊿Ta
I_FPT
V_R
I_O
V_O
V_CC
P_O
T_opr
T_stg
T_sol
BV_S
Rating
20
-0.5
1
5
10
6
6
40
-40 to 100
-55 to 125
260
2500
Unit
mA
mA/°C
A
V
mA
V
V
mW
°C
°C
°C
Vrms
Note: Using continuously under heavy loads (e.g. the application of high temperature/current/voltage and the
significant change in temperature, etc.) may cause this product to decrease in the reliability significantly even
if the operating conditions (i.e. operating temperature/current/voltage, etc.) are within the absolute maximum
ratings.
Please design the appropriate reliability upon reviewing the Toshiba Semiconductor Reliability Handbook
(“Handling Precautions”/“Derating Concept and Methods”) and individual reliability data (i.e. reliability test
report and estimated failure rate, etc).
Note 1: Pulse width PW ≤ 1 μs, 300pps.
Note 2: This device is regarded as a two terminal device : pins 1, 2, 3 and 4 are shorted together,
as are pins 5, 6, 7 and 8.
Recommended Operating Conditions
Characteristic
Symbol
Min
Typ.
Max
Unit
Input current , ON
(Each Channel)
I_F(ON)
8
－
18
mA
Input voltage , OFF
(Each Channel)
V_F(OFF)
0
－
0.8
V
Supply voltage(*)
(Note 3)
V_CC
4.5
5.0
5.5
V
Operating temperature
T_opr
-40
－
100
°C
(*) This item denotes operating ranges, not meaning of recommended operating conditions.
Note 3: The detector of this product requires a power supply voltage (V_CC) of 4.5 V or higher for stable operation.
If the V_CC is lower than this value, an I_CCH may increase, or an output may be unstable.
Be sure to use the product after checking the supply current, and the operation of a power-on/-off.
Note 4: A ceramic capacitor (0.1 μF) should be connected from pin 8 (V_CC) to pin 5 (GND) to stabilize the operation
of the high gain linear amplifier. Failure to provide the bypass may impair the switching property.
The total lead length between capacitor and coupler should not exceed 1 cm.
2
2008-06-11