TLP2066 Datasheet, PDF (2/6 Pages) Toshiba Semiconductor – High Speed Interface 3.3V Supply Voltage

TLP2066
Absolute Maximum Ratings (Ta=25°C)
Characteristic
Forward current
Forward current derating (Ta≥85°C)
Peak transient forward current (Note1)
Reverse voltage
Output current
Output voltage
Supply voltage
Output power dissipation
Operating temperature range
Storage temperature range
Lead solder temperature(10s)
Isolation voltage
(AC,1min.,R.H.≤60%,Ta=25°C)
(Note2)
Symbol
IF
ΔIF/ΔTa
IFPT
VR
IO
VO
VCC
PO
Topr
Tstg
Tsol
Rating
25
-0.7
1
6
10
6
6
40
-40~100
-55~125
260
Unit
mA
mA/°C
A
V
mA
V
V
mW
°C
°C
°C
BVs
3750
Vrms
Note: Using continuously under heavy loads (e.g. the application of high temperature/current/voltage and the
significant change in temperature, etc.) may cause this product to decrease in the reliability significantly even
if the operating conditions (i.e. operating temperature/current/voltage, etc.) are within the absolute maximum
ratings.
Please design the appropriate reliability upon reviewing the Toshiba Semiconductor Reliability Handbook
(“Handling Precautions”/“Derating Concept and Methods”) and individual reliability data (i.e. reliability test
report and estimated failure rate, etc).
Note1: Pulse width PW≤1us, 300pps.
Note2: This device is regarded as a two terminal device: pins 1 and 3 are shorted together, as are
pins 4, 5 and 6.
Recommended Operating Conditions
Characteristic
Symbol
Min
Typ.
Max
Unit
Input current , ON
Input voltage , OFF
IF(ON)
8
VF(OFF)
0
—
18
mA
—
0.8
V
Supply voltage(*)
(Note3)
VCC
3.0
3.3
3.6
V
(*) This item denotes operating ranges, not meaning of recommended operating conditions.
Note: Recommended operating conditions are given as a design guideline to obtain expected
performance of the device. Additionally, each item is an independent guideline respectively.
In developing designs using this product, please confirm specified characteristics shown in this
document.
Note3: The detector of this product requires a power supply voltage (VCC) of 3.0 V higher for stable operation.
If the VCC is lower than this value, an ICCH may increase, or an output may be unstable.
Be sure to use the product after checking the supply current, and the operation of a power-on/-off.
Note 4: A ceramic capacitor(0.1 μF) should be connected from pin 6 to pin 4 to stabilize the operation of the
high gain linear amplifier. Failure to provide the bypass may impair the switching property.
The total lead length between capacitor and coupler should not exceed 1 cm.
2
2007-11-20