LMC6001-MIL Datasheet, PDF (9/18 Pages) Texas Instruments – Ultra, Ultra-Low Input Current Amplifier

www.ti.com
6 Detailed Description
LMC6001-MIL
SNOSD60 – JUNE 2017
6.1 Overview
LMC6001-MIL has an extremely low input current of 25 fA. In addition, its ultra-low input current noise of 0.13
fA/√Hz allows almost noiseless amplification of high-resistance signal sources. LMC6001-MIL is ideally suited for
electrometer applications requiring ultra-low input leakage current such as sensitive photodetection
transimpedance amplifiers and sensor amplifiers.
6.2 Functional Block Diagram
6.3 Feature Description
6.3.1 Amplifier Topology
The LMC6001-MIL incorporates a novel op amp design topology that enables it to maintain rail-to-rail output
swing even when driving a large load. Instead of relying on a push-pull unity gain output buffer stage, the output
stage is taken directly from the internal integrator, which provides both low output impedance and large gain.
Special feed-forward compensation design techniques are incorporated to maintain stability over a wider range of
operating conditions than traditional op amps. These features make the LMC6001-MIL both easier to design with,
and provide higher speed than products typically found in this low-power class.
6.3.2 Latch-up Prevention
CMOS devices tend to be susceptible to latch-up due to their internal parasitic SCR effects. The (I/O) input and
output pins look similar to the gate of the SCR. There is a minimum current required to trigger the SCR gate
lead. The LMC6001-MIL is designed to withstand 100-mA surge current on the I/O pins. Some resistive method
should be used to isolate any capacitance from supplying excess current to the I/O pins. In addition, like an SCR,
there is a minimum holding current for any latch-up mode. Limiting current to the supply pins will also inhibit
latch-up susceptibility.
6.4 Device Functional Modes
The LMC6001-MIL has a single functional mode and operates according to the conditions listed in
Recommended Operating Conditions.
Copyright © 2017, Texas Instruments Incorporated
Product Folder Links: LMC6001-MIL
Submit Documentation Feedback
9