TSB82AA2B_14 Datasheet, PDF (83/102 Pages) Texas Instruments – OHCI-Lynx Controller

4.46 Isochronous Receive Context Match Register
The isochronous receive context match register starts an isochronous receive context running on a specified cycle
number, filters incoming isochronous packets based on tag values, and waits for packets with a specified sync value.
The n value in the following register addresses indicates the context number (n = 0, 1, 2, 3). See Table 4−36 for a
complete description of the register contents.
Type:
Offset:
Default:
Read/Write, Read only
410Ch + (32 * n)
XXXX XXXXh
Bit
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16
Default X
X
X
X
0
0
0
X
X
X
X
X
X
X
X
X
Bit
15 14 13 12 11 10
9
8
7
6
5
4
3
2
1
0
Default X
X
X
X
X
X
X
X
0
X
X
X
X
X
X
X
Table 4−36. Isochronous Receive Context Match Register Description
BIT
31
30
29
28
27
26−12
11−8
7
6
5−0
FIELD NAME
tag3
tag2
tag1
tag0
RSVD
cycleMatch
sync
RSVD
tag1SyncFilter
channelNumber
TYPE
R/W
R/W
R/W
R/W
R
R/W
R/W
R
R/W
R/W
DESCRIPTION
If bit 31 is set to 1, this context matches on isochronous receive packets with a tag field of 11b.
If bit 30 is set to 1, this context matches on isochronous receive packets with a tag field of 10b.
If bit 29 is set to 1, this context matches on isochronous receive packets with a tag field of 01b.
If bit 28 is set to 1, this context matches on isochronous receive packets with a tag field of 00b.
Reserved. Bit 27 returns 0 when read.
Contains a 15-bit value, corresponding to the low-order two bits of cycleSeconds and the 13-bit
cycleCount field in the cycleStart packet. If bit 29 (cycleMatchEnable) in the isochronous receive
context control register (see Section 4.44, Isochronous Receive Context Control Register) is set to 1,
this context is enabled for receives when the two low-order bits of the bus isochronous cycle timer
register at OHCI offset F0h (see Section 4.34, Isochronous Cycle Timer Register) cycleSeconds field
(bits 31−25) and cycleCount field (bits 24−12) value equal this field (cycleMatch) value.
This 4-bit field is compared to the sync field of each isochronous packet for this channel when the
command descriptor w field is set to 11b.
Reserved. Bit 7 returns 0 when read.
If bit 6 and bit 29 (tag1) are set to 1, packets with tag 01b are accepted into the context if the two most
significant bits of the packet sync field are 00b. Packets with tag values other than 01b are filtered
according to bit 28 (tag0), bit 30 (tag2), and bit 31 (tag3) without any additional restrictions.
If this bit is cleared, this context matches on isochronous receive packets as specified in bits 28−31
(tag0−tag3) with no additional restrictions.
This 6-bit field indicates the isochronous channel number for which this isochronous receive DMA
context accepts packets.
4−40