THS4503-EP_17 Datasheet, PDF (8/40 Pages) Texas Instruments – WIDEBAND, LOW-DISTORTION FULLY DIFFERENTIAL AMPLIFIERS

THS4503−EP
SGLS291A − APRIL 2005 − JANUARY 2012
TYPICAL CHARACTERISTICS
Table of Graphs (5 V)
Small signal unity gain frequency response
Small signal frequency response
0.1 dB gain flatness frequency response
Harmonic distortion (single-ended input to differential output) vs Frequency
Harmonic distortion (differential input to differential output) vs Frequency
Harmonic distortion (single-ended input to differential output) vs Output voltage swing
Harmonic distortion (differential input to differential output) vs Output voltage swing
Harmonic distortion (single-ended input to differential output) vs Load resistance
Harmonic distortion (differential input to differential output) vs Load resistance
Slew rate vs Differential output voltage step
Large-signal transient response
Small-signal transient response
Voltage and current noise vs Frequency
Rejection ratios vs Frequency
Rejection ratios vs Case temperature
Output balance error vs Frequency
Open-loop gain and phase vs Frequency
Open-loop gain vs Case temperature
Input bias and offset current vs Case temperature
Quiescent current vs Supply voltage
Input offset voltage vs Case temperature
Common-mode rejection ratio vs Input common-mode range
Output drive vs Case temperature
Harmonic distortion (single-ended and differential input) vs Output common-mode range
Small signal frequency response at V_OCM
Output offset voltage vs Output common-mode voltage
Quiescent current vs Power-down voltage
Turnon and turnoff delay times
Single-ended output impedance in power down vs Frequency
Power-down quiescent current vs Case temperature
Power-down quiescent current vs Supply voltage
www.ti.com
FIGURE
50
51
52
53, 54, 61, 63
55, 56, 62, 64
57, 58, 65, 67
59, 60, 66, 68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
8