THS4271_16 Datasheet, PDF (8/50 Pages) Texas Instruments – LOW NOISE, HIGH SLEW RATE, UNITY GAIN STABLE VOLTAGE FEEDBACK AMPLIFIER

THS4271
THS4275
SLOS397F – JULY 2002 – REVISED OCTOBER 2009
TYPICAL CHARACTERISTICS
Table of Graphs (±5 V)
Small-signal unity gain frequency response
Small-signal frequency response
0.1-dB gain flatness frequency response
Large-signal frequency response
Slew rate
vs Output voltage
Harmonic distortion
vs Frequency
Harmonic distortion
vs Output voltage swing
Third-order intermodulation distortion vs Frequency
Third-order intercept point
vs Frequency
Voltage and current noise
vs Frequency
Differential gain
vs Number of loads
Differential phase
vs Number of loads
Settling time
Quiescent current
vs Supply voltage
Output voltage
vs Load resistance
Frequency response
vs Capacitive load
Open-loop gain and phase
vs Frequency
Open-loop gain
vs Supply voltage
Rejection ratios
vs Frequency
Rejection ratios
vs Case temperature
Common-mode rejection ratio
vs Input common-mode range
Input offset voltage
vs Case temperature
Input bias and offset current
vs Case temperature
Small-signal transient response
Large-signal transient response
Overdrive recovery
Closed-loop output impedance
vs Frequency
Power-down quiescent current
vs Supply voltage
Power-down output impedance
vs Frequency
Turn-on and turn-off delay times
www.ti.com
FIGURE
1
2
3
4
5
6, 7, 8, 9
10, 11, 12, 13
14, 16
15, 17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
8
Submit Documentation Feedback
Copyright © 2002–2009, Texas Instruments Incorporated
Product Folder Link(s): THS4271 THS4275