LMD18200QML Datasheet, PDF (8/18 Pages) Texas Instruments – 2.4A, 55V H-Bridge

Switching Time Definitions
20160909
Pinout Description
(See Connection Diagram)
Pin 1, BOOTSTRAP 1 Input: Bootstrap capacitor pin for half H-bridge number 1. The recommended capacitor (10 nF) is connected
between pins 1 and 2.
Pin 2, OUTPUT 1: Half H-bridge number 1 output.
Pin 3, DIRECTION Input: See Table 1. This input controls the direction of current flow between OUTPUT 1 and OUTPUT 2 (pins
2 and 10) and, therefore, the direction of rotation of a motor load.
Pin 4, BRAKE Input: See Table 1. This input is used to brake a motor by effectively shorting its terminals. When braking is desired,
this input is taken to a logic high level and it is also necessary to apply logic high to PWM input, pin 5. The drivers that short the
motor are determined by the logic level at the DIRECTION input (Pin 3): with Pin 3 logic high, both current sourcing output transistors
are ON; with Pin 3 logic low, both current sinking output transistors are ON. All output transistors can be turned OFF by applying
a logic high to Pin 4 and a logic low to PWM input Pin 5; in this case only a small bias current (approximately −1.5 mA) exists at
each output pin.
Pin 5, PWM Input: See Table 1. How this input (and DIRECTION input, Pin 3) is used is determined by the format of the PWM
Signal.
Pin 6, V_S Power Supply
Pin 7, GROUND Connection: This pin is the ground return, and is internally connected to the mounting tab.
Pin 8, CURRENT SENSE Output: This pin provides the sourcing current sensing output signal, which is typically 377 μA/A.
Pin 9, THERMAL FLAG Output: This pin provides the thermal warning flag output signal. Pin 9 becomes active-low at 145°C
(junction temperature). However the chip will not shut itself down until 170°C is reached at the junction.
Pin 10, OUTPUT 2: Half H-bridge number 2 output.
Pin 11, BOOTSTRAP 2 Input: Bootstrap capacitor pin for Half H-bridge number 2. The recommended capacitor (10 nF) is con-
nected between pins 10 and 11.
7
www.national.com