TMS320C6412AZNZ5 Datasheet, PDF (70/163 Pages) Texas Instruments – TMS320C6412 Fixed-Point Digital Signal Processor

Terminal Functions
Table 2−10. Terminal Functions (Continued)
SIGNAL
NAME
GDK/
GNZ
TYPE^†
IPD/
IPU^‡
DESCRIPTION
RESERVED FOR TEST (CONTINUED)
RSV00
AA3
A
—
RSV01
AB3
I
—
RSV02
AC4
O/Z
—
RSV05
E14
I
IPD
RSV06
W7
A
—
RSV09
AC1
RSV19
AB15
RSV22
AB14
RSV25
AB13
RSV35
AC8
RSV44
AB11
RSV45
AB12
RSV49
D7
RSV50
C7
RSV51
C8
RSV52
D8
RSV54
B9
Reserved (leave unconnected, do not connect to power or ground)
RSV55
C9
RSV56
D9
RSV58
B10
RSV59
C10
RSV60
D10
RSV62
B11
RSV63
C11
RSV64
D11
RSV65
E11
RSV66
B12
RSV67
C12
RSV68
D12
RSV69
E12
RSV70
E13
† _{I = Input, O = Output, Z = High impedance, S = Supply voltage, GND = Ground}
‡ _{IPD = Internal pulldown, IPU = Internal pullup. (These IPD/IPU signal pins feature a 30-kΩ IPD or IPU resistor. To pull up a signal to the opposite}
supply rail, a 1-kΩ resistor should be used.)
§ _{These pins are multiplexed pins. For more details, see the Device Configurations section of this data manual.}
¶ _{PLLV is not part of external voltage supply. See the Clock PLL section for information on how to connect this pin.}
# _{A = Analog signal (PLL Filter)}
|| _{The EMU0 and EMU1 pins are internally pulled up with 30-kΩ resistors; therefore, for emulation and normal operation, no external}
pullup/pulldown resistors are necessary. However, for boundary scan operation, pull down the EMU1 and EMU0 pins with a dedicated 1-kΩ
resistor.
70 SPRS219J
April 2003 − Revised October 2010