DRV2603ERM Datasheet, PDF (7/28 Pages) Texas Instruments – DRV2603 ERM/LRA Haptic Driver Evaluation Kit

www.ti.com
Hardware Configuration
Figure 6. LRA Click and Release Effect
Figure 7. LRA Scroll Wheel Effect
2.2.5 Mode 4 – ERM Clicks
Mode 4 showcases ERM clicks and double clicks. Similarly to the LRA, compare the click with braking and
without braking and notice the sharper feel with braking.
2.2.6 Mode 5 – Concentration Game
Mode 5 is a game that incorporates the various LRA and ERM effects. This can be used to demonstrate
haptics in a real application.
To begin playing Concentration:
1. Press any of the large effect buttons.
2. The game will then count down.
3. Once the countdown completes, a button will light and an effect will play.
4. Repeat the pattern by pressing the same button.
5. After each successfully repeated pattern, the board will repeat the same pattern and add one
additional button to the sequence.
3 Hardware Configuration
The DRV2603EVM-CT is very flexible and can be used to completely evaluate the DRV2603. The
following sections list the various hardware configurations.
3.1 Input and Output Overview
The DRV2603EVM-CT allows complete evaluation of the DRV2603 though test points, jacks and
connectors. Table 2 gives a brief description of the hardware.
Signal
PWM
EN
OUT+ / OUT-
OUT
USB
VBAT
SBW
I²C
Table 2. Hardware Overview
Description
External DRV2603 PWM input
External DRV2603 enable control
Filtered output test points for observation, connect to oscilloscope or
measurement equipment
Unfiltered output terminal block, connect to actuator
USB power (5V)
External Supply Power (2.5V-5.2V)
MSP430 programming header
MSP430 I²C™ bus
I/O
Input / Observe
Input / Observe
Output
Output
Input
Input
Input / Output
Input / Output
SLOU340A – May 2012 – Revised May 2012
Submit Documentation Feedback
DRV2603 ERM/LRA Haptic Driver Evaluation Kit 7
Copyright © 2012, Texas Instruments Incorporated