DRV2603ERM Datasheet, PDF (3/28 Pages) Texas Instruments – DRV2603 ERM/LRA Haptic Driver Evaluation Kit

www.ti.com
Getting Started
4 MSP430 Pin-Out........................................................................................................... 16
1 Getting Started
The DRV2603 can be used as a demonstration or evaluation tool. When the DRV2603EVM-CT Evaluation
Module is powered on, a demo application automatically starts. To power the board, connect the
DRV2603EVM-CT to an available USB port on your computer using the included mini-USB cable. The
demo begins with a board power-up sequence and then will enter the demo effects mode. The four larger
buttons (B1-B4) can be used to sample haptic effects using both the ERM and LRA motor in the top right
corner. The two smaller mode buttons (“–“, “+”) are used to change between the different sets of effects.
See the DRV2603 Demonstration Program section for a more detailed description of the demo application.
USB Power
DRV2603 Driver
Increment Mode
Power Select Pins
Decrement Mode
ERM and LRA Actuators
External
Power
MSP
DRV
MSP430
DRV2603
OUT
Actuators
Programmer
Connector
Effect Buttons
Press to play haptic effects.
Figure 1. Board Diagram
SLOU340A – May 2012 – Revised May 2012
DRV2603 ERM/LRA Haptic Driver Evaluation Kit
3
Submit Documentation Feedback
Copyright © 2012, Texas Instruments Incorporated