SN74CB3T3384_15 Datasheet, PDF (5/19 Pages) Texas Instruments – 10-BIT FET BUS SWITCH 2.5-V/3.3-V LOW-VOLTAGE BUS SWITCH WITH 5-V-TOLERANT LEVEL SHIFTER

SN74CB3T3384
10ĆBIT FET BUS SWITCH
2.5ĆV/3.3ĆV LOWĆVOLTAGE BUS SWITCH WITH 5ĆVĆTOLERANT LEVEL SHIFTER
SCDS159B − OCTOBER 2003 − REVISED MARCH 2004
electrical characteristics over recommended operating free-air temperature range (unless
otherwise noted)
PARAMETER
TEST CONDITIONS
MIN TYP† MAX UNIT
VIK
VCC = 3 V,
II = −18 mA
−1.2 V
VOH
See Figures 3 and 4
IIN
Control inputs
VCC = 3.6 V,
VIN = 3.6 V to 5.5 V or GND
±10 µA
VCC = 3.6 V,
II
Switch ON,
VIN = GND
VI = VCC − 0.7 V to 5.5 V
VI = 0.7 V to VCC − 0.7 V
VI = 0 to 0.7 V
±20
−40 µA
±5
IOZ‡
VCC = 3.6 V,
VO = 0 to 5.5 V,
VI = 0,
Switch OFF,
VIN = VCC
±10 µA
VCC = 0,
Ioff
VO = 0 to 5.5 V,
VI = 0
10 µA
ICC
∆ICC§
Control inputs
VCC = 3.6 V,
II/O = 0,
Switch ON or OFF,
VIN = VCC or GND
VCC = 3 V to 3.6 V,
One input at VCC − 0.6 V,
Other inputs at VCC or GND
VI = VCC or GND
VI = 5.5 V
40
µA
40
300 µA
Cin
Control inputs
VCC = 3.3 V,
VIN = VCC or GND
3
pF
Cio(OFF)
VCC = 3.3 V,
VI/O = 5.5 V, 3.3 V, or GND,
Switch OFF,
VIN = VCC
5
pF
Cio(ON)
VCC = 3.3 V,
Switch ON,
VIN = GND
VI/O = 5.5 V or 3.3 V
VI/O = GND
4
pF
12
VCC = 2.3 V,
TYP at VCC = 2.5 V,
ron¶
VI = 0
VCC = 3 V,
VI = 0
IO = 24 mA
IO = 16 mA
IO = 64 mA
IO = 32 mA
5
8
5
8
Ω
5
7
5
7
VIN and IIN refer to control inputs. VI, VO, II, and IO refer to data pins.
† _{All typical values are at VCC = 3.3 V (unless otherwise noted), TA = 25°C.}
‡ _{For I/O ports, the parameter IOZ includes the input leakage current.}
§ _{This is the increase in supply current for each input that is at the specified TTL voltage level, rather than VCC or GND.}
¶ _{Measured by the voltage drop between A and B terminals at the indicated current through the switch. ON-state resistance is determined by the}
lower of the voltages of the two (A or B) terminals.
• POST OFFICE BOX 655303 DALLAS, TEXAS 75265
5