DS90C031QML_16 Datasheet, PDF (5/21 Pages) Texas Instruments – LVDS Quad CMOS Differential Line Driver

DS90C031QML
www.ti.com
SNLS202B – MARCH 2006 – REVISED MARCH 2013
AC Parameters
The following conditions apply, unless otherwise specified.
AC: V_CC = 4.5V / 5.0V / 5.5V, R_L = 100Ω (between outputs), C_L = 20pF (each output to Gnd)
Symbol
Parameter
Conditions
Notes Min Max
t_PHLD
t_PLHD
t_SkD
t_Sk1
t_Sk2
t_PHZ
t_PLZ
t_PZH
t_PZL
Differential Propagation Delay
High to Low
Differential Propagation Delay
Low to High
Differential Skew |tPHLD-tPLHD|
Channel to Channel Skew
Chip to Chip Skew
Disable Time High to Z
Disable Time Low To Z
Enable Time Z to High
Enable Time Z to Low
0.5 5.0
0.5 5.0
3.0
(1)
3.0
(2)
4.5
(3)
20
(3)
20
(3)
20
(3)
20
Units
ns
ns
ns
ns
ns
ns
ns
ns
ns
Sub-
groups
9, 10, 11
9, 10, 11
9, 10, 11
9, 10, 11
9, 10, 11
9, 10, 11
9, 10, 11
9, 10, 11
9, 10, 11
(1) Channel-to-Channel Skew is defined as the difference between the propagation delay of the channel and the other channels in the
same chip with an event on the inputs.
(2) Chip to Chip Skew is defined as the difference between the minimum and maximum specified differential propagation delays.
(3) Parameter guaranteed, not tested 100%
AC/DC Parameters - Post Radiation Limits ⁽¹⁾
Symbol
Parameter
Conditions
I_CC
Drivers Enabled Supply Current D_I - Hi or Low, En = Gnd,
En* = V_CC
I_CCZ
Drivers Disabled Supply Current D_I - Hi or Low, En = Gnd,
En* = V_CC
Notes
Min Max
30
30
Units
mA
mA
Sub-
groups
1
1
(1) Pre and Post irradiation limits are identical to those listed under AC and DC electrical characteristics except as listed in the “Post
Radiation Limits” table. Radiation end point limits for the noted parameters are guaranteed only for the conditions, as specified.
Copyright © 2006–2013, Texas Instruments Incorporated
Product Folder Links: DS90C031QML
Submit Documentation Feedback
5