LM3S5662 Datasheet, PDF (461/841 Pages) Texas Instruments – Stellaris® LM3S5662 Microcontroller

Stellaris® LM3S5662 Microcontroller
Figure 12-4. Differential Sampling Range, V_{IN_ODD} = 2.25 V
ADC Conversion Result
0x3FF
0x2FF
0x1FF
0.75 V
-1.5 V
2.25 V
3.0 V
0.75 V
- Input Saturation
1.5 V
VIN_EVEN
DV
12.3.6
Internal Temperature Sensor
The temperature sensor serves two primary purposes: 1) to notify the system that internal temperature
is too high or low for reliable operation, and 2) to provide temperature measurements for calibration
of the Hibernate module RTC trim value.
The temperature sensor does not have a separate enable, since it also contains the bandgap
reference and must always be enabled. The reference is supplied to other analog modules; not just
the ADC.
The internal temperature sensor provides an analog temperature reading as well as a reference
voltage. The voltage at the output terminal SENSO is given by the following equation:
SENSO = 2.7 - ((T + 55) / 75)
This relation is shown in Figure 12-5 on page 462.
November 17, 2011
461
Texas Instruments-Production Data