THS4511_14 Datasheet, PDF (4/36 Pages) Texas Instruments – WIDEBAND, LOW-NOISE, LOW-DISTORTION FULLY-DIFFERENTIAL AMPLIFIER

THS4511
SLOS471E – SEPTEMBER 2005 – REVISED NOVEMBER 2009
www.ti.com
ELECTRICAL CHARACTERISTICS: V_S+ – V_S– = 5 V
Test conditions unless otherwise noted: V_S+ = 5 V, V_S– = 0 V, G = 0 dB, CM = open, V_O = 2 V_PP, R_F = 349 Ω, R_L = 200 Ω
differential, T = +25°C single-ended input, differential output, input referenced to ground, and output referenced to midsupply.
PARAMETER
AC PERFORMANCE (see Figure 38)
Small-Signal Bandwidth
Gain-Bandwidth Product
Bandwidth for 0.1-dB flatness
Large-Signal Bandwidth
Slew Rate (Differential)
Rise Time
Fall Time
Settling Time to 1%
Settling Time to 0.1%
2^nd Order Harmonic Distortion
3^rd Order Harmonic Distortion
2^nd Order Intermodulation Distortion
3^rd Order Intermodulation Distortion
2^nd Order Output Intercept Point
3^rd Order Output Intercept Point
1-dB Compression Point⁽²⁾
Noise Figure
Input Voltage Noise
Input Current Noise
DC PERFORMANCE
Open-Loop Voltage Gain (A_OL)
Input Offset Voltage
Average Offset Voltage Drift
Input Bias Current
Average Bias Current Drift
Input Offset Current
Average Offset Current Drift
TEST CONDITIONS
G = 0 dB, V_O = 100 mV_PP
G = 6 dB, V_O = 100 mV_PP
G = 0 dB, V_O = 2 V_PP
G = 6 dB, V_O = 2 V_PP
G = 10 dB, V_O = 2 V_PP
V_O = 2-V Step
f = 10 MHz
f = 50 MHz
f = 100 MHz
f = 10 MHz
f = 50 MHz
f = 100 MHz
200-kHz tone spacing,
R_L = 100 Ω
200-kHz tone spacing,
R_L = 100 Ω
f_C = 70 MHz
f_C = 140 MHz
50-Ω system, 10 MHz
f > 10 MHz
f > 10 MHz
f_C = 70 MHz
f_C = 140 MHz
f_C = 70 MHz
f_C = 140 MHz
f_C = 70 MHz
f_C = 140 MHz
f_C = 70 MHz
f_C = 140 MHz
T_A = +25°C
T_A = –40°C to +85°C
T_A = +25°C
T_A = –40°C to +85°C
T_A = +25°C
T_A = –40°C to +85°C
THS4511
TEST
MIN
TYP
MAX
UNITS LEVEL⁽¹⁾
1.6
1.4
2
160
620
1.35
4900
0.5
0.5
3.3
16
–117
–80
–64
–106
–92
–80
–78
–56
–88
–71.4
76.3
53.4
42
34
12.2
10.8
21.8
2
1.5
GHz
GHz
MHz
GHz
V/µs
ns
ns
ns
ns
dBc
C
dBc
dBm
dBm
dB
nV/√Hz
pA/√Hz
63
dB
C
1
4
mV
A
1
5
2.3
µV/°C
B
1.75
8
15.5
µA
A
8
18.5
20
nA/°C
B
0.5
3.6
µA
A
0.5
7
7
nA/°C
B
(1) Test levels: (A) 100% tested at +25°C. Over-temperature limits by characterization and simulation. (B) Limits set by characterization and
simulation. (C) Typical value only for information.
(2) The 1-dB compression point is measured at the load with 50-Ω double termination. Add 3 dB to refer to amplifier output.
4
Submit Documentation Feedback
Product Folder Link(s): THS4511
Copyright © 2005–2009, Texas Instruments Incorporated