THS4511_14 Datasheet, PDF (18/36 Pages) Texas Instruments – WIDEBAND, LOW-NOISE, LOW-DISTORTION FULLY-DIFFERENTIAL AMPLIFIER

THS4511
SLOS471E – SEPTEMBER 2005 – REVISED NOVEMBER 2009
S-Parameter, Slew Rate, Transient Response,
Settling Time, Output Impedance, Overdrive,
Output Voltage, and Turn-On/Off Time
The circuit shown in Figure 40 is used to measure
s-parameters, slew rate, transient response, settling
time, output impedance, overdrive recovery, output
voltage swing, and turn-on/turn-off times of the
amplifier. For output impedance, the signal is injected
at V_OUT with V_IN left open and the drop across the
49.9-Ω resistor is used to calculate the impedance
seen looking into the amplifier output.
Because S₂₁ is measured single-ended at the load
with 50-Ω double termination, add 12 dB to refer to
the amplifier output as a differential signal.
From ^VIN
50-W
Source
RG
R IT
0.22 mF
49.9 W
RG
R IT
RF
5V
THS4511
CM
RF
49.9 W
49.9 W
Open
0.22 mF
V_OUT+
V_OUT-
To 50-W
Test
Equipment
Figure 40. S-Parameter, SR, Transient Response,
Settling Time, Z_O, Overdrive Recovery, V_OUT
Swing, and Turn-On/Off Test Circuit
CM Input
The circuit shown in Figure 41 is used to measure the
frequency response and input impedance of the CM
input. Frequency response is measured single-ended
at V_OUT+ or V_OUT– with the input injected at V_IN, R_CM =
0 Ω, and R_CMT = 49.9 Ω. The input impedance is
measured with R_CM = 49.9 Ω with R_CMT = open, and
calculated by measuring the voltage drop across R_CM
to determine the input current.
0.22 mF
49.9 W
0.22 mF
49.9 W
RG
RIT
RG
RIT
RF
5V
THS4511
CM
RF
49.9 W
49.9 W
RCM
RCMT
www.ti.com
VOUT–
To
50-W
Test
VOUT+ _Equipment
VIN From
50-W
source
Figure 41. CM Input Test Circuit
CMRR and PSRR
The circuit shown in Figure 42 is used to measure the
CMRR and PSRR of V_S+ and V_S–. The input is
switched appropriately to match the test being
performed.
V_S+
PSRR+
From ^VIN
50 W
Source
CMRR
PSRR-
V_S-
348 W
5V
100 W
100 W
THS4511
CM
69.8 W
49.9 W
49.9 W ^{100 W}
Open
0.22 mF
Output
Measured
Here
With High
Impedance
Differential
Probe
348 W
Figure 42. CMRR and PSRR Test Circuit
18
Submit Documentation Feedback
Product Folder Link(s): THS4511
Copyright © 2005–2009, Texas Instruments Incorporated