OPA836 Datasheet, PDF (35/49 Pages) Texas Instruments – Very Low-Power, Rail-to-Rail Out, Negative Rail In, VFB Op Amp

www.ti.com
OPA836
OPA2836
SLOS712D – JANUARY 2011 – REVISED OCTOBER 2011
V_S = 5 V,
0
V_OUT = 100 mV_pp
-10
MFB
-20
Sallen-Key
-30
-40
1k
10k
100k
1M
f - Frequency - Hz
Figure 74. MFB and Sallen-Key 2_nd Order Low-Pass Butterworth Filter Response
MFB and Sallen-Key filter circuits offer similar performance. The main difference is the MFB is an inverting
amplifier in the pass band and the Sallen-Key is non-inverting. The primary pro for each is the Sallen-Key in unity
gain has no resistor gain error term, and thus no sensitivity to gain error, while the MFB has inherently better
attenuation properties beyond the bandwidth of the op amp.
Audio Frequency Performance
The OPA836 and OPA2836 provide excellent audio performance with very low quiescent power. To show
performance in the audio band, a 2700 series Audio Analyzer from Audio Precision was used to test THD+N and
FFT at 1V_RMS output voltage. Figure 75 is the test circuit used. Note the 100pF capacitor to ground on the input
helped to decouple noise pick up in the lab and improved noise performance.
Figure 76 shows the THD+N performance with 100kΩ and 300Ω loads, with A-weighting, and with no weighting.
Both loads show similar performance. With no weighting the THD+N performance is dominated by the noise
whereas A-weighting provides filtering that improves the noise.
Figure 77 and Figure 78 show FFT output with a 1 kHz tone and 100kΩ and 300Ω loads. To show relative
performance of the device versus the test set, one channel has the OPA836 in line between generator output
and analyzer input and the other channel is in “Gen Mon” loopback mode, which internally connects the signal
generator to the analyzer input. With 100 kΩ load, Figure 77, the curves are basically indistinguishable from each
other except for noise, which means the OPA836 cannot be directly measured. With 300 Ω load, Figure 78, the
main difference between the curves is OPA836 shows slightly higher even order harmonics, but odd order is
masked by the test set performance.
V_IN
From AP
+2.5 V
100 pF ^{OPA 836}
V_OUT
To AP
10 W
-2.5 V
Figure 75. OPA836 AP Analyzer Test Circuit
Copyright © 2011, Texas Instruments Incorporated
Product Folder Link(s): OPA836 OPA2836
Submit Documentation Feedback
35