English
Language : 

BQ27741-G1_14 Datasheet, PDF (33/39 Pages) Texas Instruments – Single Cell Li-Ion Battery Fuel Gauge with Integrated Protection
bq27741-G1
www.ti.com
GLOSSARY
SLUSBF2 – JULY 2013
ACK
ADC
BCA
CC
CCA
CE
cWh
DF
DOD
DOD0
EOC
FC
FCC
FIFO
FVCA
GPIO
HDQ
IC
ID
IO
IT
I2C
LDO
LSB
LT
MAC
mAh
MSB
mWh
NACK
NTC
OCV
OTC
OTD
Qmax
RM
RW
SCL
SDA
SE
SOC
SOC1
SOCF
TCA
TS
TTE
TTF
Acknowledge character
Analog-to-digital converter
Board calibration
Coulomb counter
Coulomb counter calibration
Chip enable
Centiwatt-hour
Data flash
Depth of discharge in percent as related to Qmax. 100% corresponds to empty battery.
Depth of discharge that was looked up in the DOD (OCV) table based on OCV measurement in relaxed state.
End of charge
Fully charged
Full charge capacity. Total capacity of the battery compensated for present load current, temperature, and aging effects
(reduction in chemical capacity and increase in internal impedance).
First in, first out
Fast voltage and current acquisition
General-purpose input output
High-speed data queue
Integrated circuit
Identification
Input or output
Impedance Track™
Inter-integrated circuit
Low dropout
Least significant bit
Lifetime
Manufacturer access command or control command
Milliamp-hour
Most significant bit
Milliwatt-hour
Negative acknowledge character
Negative temperature coefficient
Open-circuit voltage. Voltage measured on fully-relaxed battery with no load applied.
Overtemperature in charge
Overtemperature in discharge
Maximum chemical capacity
Remaining capacity
Read or write
Serial clock: programmable serial clock used in the I2C interface
Serial data: serial data bus in the I2C interface
Shutdown enable
State-of-charge in percent related to FCC
State-of-charge initial
State-of-charge final
Terminate charge alarm
Temperature status
Time-to-empty
Time-to-full
Copyright © 2013, Texas Instruments Incorporated
Product Folder Links: bq27741-G1
Submit Documentation Feedback
33