TCA9617B Datasheet, PDF (3/24 Pages) Texas Instruments – Level-Translating FM+ I2C Bus Repeater

www.ti.com
TCA9617B
SCPS259A – DECEMBER 2014 – REVISED DECEMBER 2014
6 Pin Configuration and Functions
DGK PACKAGE
(TOP VIEW)
VCCA 1
SCLA 2
SDAA 3
GND 4
8 VCCB
7 SCLB
6 SDAB
5 EN
PIN
NAME
NO.
EN
5
GND
4
SCLA
2
SCLB
7
SDAA
3
SDAB
6
VCCA
1
VCCB
8
Pin Functions
DESCRIPTION
Active-high repeater enable input
Supply ground
I²C SCL line, A side. Connect to V_CCA through a pull-up resistor.
I²C SCL line, B side. Connect to V_CCB through a pull-up resistor.
I²C SDA line, A side. Connect to V_CCA through a pull-up resistor.
I²C SDA line, B side. Connect to V_CCB through a pull-up resistor.
A-side supply voltage (0.8 V to 5.5 V)
B-side and device supply voltage (2.2 V to 5.5 V)
7 Specifications
7.1 Absolute Maximum Ratings⁽¹⁾
over operating free-air temperature range (unless otherwise noted)
MIN
MAX UNIT
V_CCB
V_CCA
V_I
V_I/O
I_IK
I_OK
I_O
T_stg
Supply voltage range
Supply voltage range
Enable input voltage range⁽²⁾
I²C bus voltage range⁽²⁾
Input clamp current
Output clamp current
Continuous output current
Continuous current through V_CC or GND
Storage temperature range
V_I < 0
V_O < 0
–0.5
7V
–0.5
7V
–0.5
7V
–0.5
7V
–50
mA
–50
±50 mA
±100 mA
–65
150 °C
(1) Stresses beyond those listed under "absolute maximum ratings" may cause permanent damage to the device. These are stress ratings
only, and functional operation of the device at these or any other conditions beyond those indicated under "recommended operating
conditions" is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
(2) The input negative-voltage and output voltage ratings may be exceeded if the input and output current ratings are observed.
7.2 ESD Ratings
V_(ESD) Electrostatic discharge
Human-body model (HBM), per ANSI/ESDA/JEDEC JS-001⁽¹⁾
Charged-device model (CDM), per JEDEC specification JESD22-
C101 ⁽²⁾
VALUE
±4000
±1500
UNIT
V
(1) JEDEC document JEP155 states that 500-V HBM allows safe manufacturing with a standard ESD control process. Manufacturing with
less than 500-V HBM is possible with the necessary precautions.
(2) JEDEC document JEP157 states that 250-V CDM allows safe manufacturing with a standard ESD control process. Manufacturing with
less than 250-V CDM is possible with the necessary precautions.
Copyright © 2014, Texas Instruments Incorporated
Product Folder Links: TCA9617B
Submit Documentation Feedback
3