OPA170_12 Datasheet, PDF (3/30 Pages) Texas Instruments – 36V, Single-Supply, SOT553, Low-Power OPERATIONAL AMPLIFIERS

www.ti.com
OPA170
OPA2170
OPA4170
SBOS557A – AUGUST 2011 – REVISED SEPTEMBER 2011
ELECTRICAL CHARACTERISTICS
Boldface limits apply over the specified temperature range, T_A = –40°C to +125°C.
At T_A = +25°C, V_CM = V_OUT = V_S/2, and R_L = 10kΩ connected to V_S/2, unless otherwise noted.
OPA170, OPA2170, OPA4170
PARAMETER
TEST CONDITIONS
MIN
TYP
MAX UNIT
OFFSET VOLTAGE
Input offset voltage
V_OS
Over temperature
0.25
±1.8
mV
±2
mV
Drift
vs power supply
Channel separation, dc
dV_OS/dT
PSRR
V_S = +4V to +36V
dc
±0.3
±2 µV/°C
1
±5 µV/V
5
µV/V
INPUT BIAS CURRENT
Input bias current
I_B
Over temperature
±8
±15
pA
±3.5
nA
Input offset current
I_OS
Over temperature
±4
±15
pA
±3.5
nA
NOISE
Input voltage noise
Input voltage noise density
f = 0.1Hz to 10Hz
f = 100Hz
e_n
f = 1kHz
2
µV_PP
22
nV/√Hz
19
nV/√Hz
INPUT VOLTAGE
Common-mode voltage range⁽¹⁾
Common-mode rejection ratio
INPUT IMPEDANCE
V_CM
CMRR
V_S = ±2V, (V–) – 0.1V < V_CM < (V+) – 2V
V_S = ±18V, (V–) – 0.1V < V_CM < (V+) – 2V
(V–) – 0.1V
90
104
(V+) – 2V
V
104
dB
120
dB
Differential
100 || 3
MΩ || pF
Common-mode
6 || 3
10¹² Ω || pF
OPEN-LOOP GAIN
Open-loop voltage gain
A_OL
V_S = +4V to +36V, (V–) + 0.35V < V_O < (V+) –
0.35V
110
130
dB
FREQUENCY RESPONSE
Gain bandwidth product
GBP
1.2
MHz
Slew rate
SR
G = +1
0.4
V/µs
Settling time
Overload recovery time
Total harmonic distortion + noise
OUTPUT
t_S
THD+N
To 0.1%, V_S = ±18V, G = +1, 10V step
To 0.01% (12 bit), V_S = ±18V, G = +1, 10V step
V_IN × Gain > V_S
G = +1, f = 1kHz, V_O = 3V_RMS
20
µs
28
µs
2
µs
0.0002
%
Voltage output swing from rail
Positive rail
Negative Rail
Over temperature
Short-circuit current
Capacitive load drive
Open-loop output resistance
POWER SUPPLY
V_O
I_SC
C_LOAD
R_O
I_L = 0mA, V_S = +4V to +36V
I_L sourcing 1mA, V_S = +4V to +36V
I_L = 0mA, V_S = +4V to +36V
I_L sinking 1mA, V_S = +4V to +36V
V_S = 5V, R_L = 10kΩ
R_L = 10kΩ, A_OL ≥ 110dB
f = 1MHz, I_O = 0A
10
mV
115
mV
8
mV
70
mV
(V–) + 0.03
(V+) – 0.05
V
(V–) + 0.35
(V+) – 0.35
V
+17/–20
mA
See Typical Characteristics
pF
900
Ω
Specified voltage range
V_S
Quiescent current per amplifier
I_Q
Over temperature
I_O = 0A
I_O = 0A
+2.7
110
+36
V
145
µA
155
µA
(1) The input range can be extended beyond (V+) – 2V up to V+. See the Typical Characteristics and Application Information sections for
additional information.
Copyright © 2011, Texas Instruments Incorporated
Submit Documentation Feedback
3
Product Folder Link(s): OPA170 OPA2170 OPA4170