English
Language : 

BQ27546-G1 Datasheet, PDF (3/38 Pages) Texas Instruments – nullSingle-Cell Li-Ion Battery Fuel Gauge
www.ti.com
6 Device Comparison Table
PART
NUMBER (1)
BQ27546YZFR-G1
BQ27546YZFT-G1
FIRMWARE
VERSION
2.00
(1) bq27546-G1 is shipped in I2C mode.
PACKAGE (1)
DSBGA-15
7 Pin Configuration and Functions
bq27546-G1
SLUSC53A – MAY 2015 – REVISED DECEMBER 2015
TA
–40°C to 85°C
COMMUNICATION
FORMAT
I2C, HDQ(1)
TAPE AND REEL
QUANTITY
3000
250
PIN
NAME
NO.
SRP
A1
SRN
VSS
SE
VCC
REGIN
HDQ
TS
CE
BAT
B1
C1, C2
C3
D1
E1
A2
B2
D2
E2
SCL
A3
SDA
B3
NC/GPIO D3, E3
Pin Functions
TYPE (1)
DESCRIPTION
IA
Analog input pin connected to the internal coulomb counter where SRP is nearest the VSS connection.
Connect to a 5-mΩ to 20-mΩ sense resistor.
IA
Analog input pin connected to the internal coulomb counter where SRN is nearest the PACK– connection.
Connect to a 5-mΩ to 20-mΩ sense resistor.
P
Device ground
O
Shutdown Enable output. Push-pull output
P
Regulator output and processor power. Decouple with a 1.0-µF ceramic capacitor to VSS.
P
Regulator input. Decouple with a 0.1-µF ceramic capacitor to VSS.
I/O HDQ serial communications line (Slave). Open-drain
IA
Pack thermistor voltage sense (use 103AT-type thermistor). ADC input
I
Chip Enable. Internal LDO is disconnected from REGIN when driven low.
IA
Cell-voltage measurement input. ADC input. Recommendation is 4.8 V maximum for conversion
accuracy.
I
Slave I2C serial communications clock input line for communication with system (Master). Use with a 10-
kΩ pull-up resistor (typical).
I/O
Slave I2C serial communications data line for communication with system (Master). Open-drain I/O. Use
with a 10-kΩ pull-up resistor (typical).
NC Do not connect for proper operation. Reserved for future GPIO.
(1) IA = Analog input, I/O = Digital input/output, P = Power connection, NC = No connect
Copyright © 2015, Texas Instruments Incorporated
Product Folder Links: bq27546-G1
Submit Documentation Feedback
3