LMC6482_16 Datasheet, PDF (28/39 Pages) Texas Instruments – LMC6482 CMOS Dual Rail-to-Rail Input and Output Operational Amplifier

LMC6482
SNOS674E – NOVEMBER 1997 – REVISED APRIL 2015
www.ti.com
9 Power Supply Recommendations
The LMC6482 can be operated over a supply range of 3 V to 15 V. To achieve noise immunity as appropriate to
the application, it is important to use good PCB layout practices for power supply rails and planes, as well as
using bypass capacitors connected between the power supply pins and ground.
10 Layout
10.1 Layout Guidelines
It is generally recognized that any circuit which must operate with less than 1000 pA of leakage current requires
special layout of the PC board. When one wishes to take advantage of the ultralow input current of the
LMC6482, typically less than 20 fA, it is essential to have an excellent layout. Fortunately, the techniques of
obtaining low leakages are quite simple. First, the user must not ignore the surface leakage of the PCB, even
through it may sometimes appear acceptably low, because under conditions of high humidity or dust or
contamination, the surface leakage will be appreciable.
To minimize the effect of any surface leakage, lay out a ring of foil completely surrounding the LM6482s inputs
and the terminals of capacitors, diodes, conductors, resistors, relay terminals, and so forth connected to the
inputs of the op-amp, as in Figure 78. To have a significant effect, guard rings should be placed on both the top
and bottom of the PCB. This PC foil must then be connected to a voltage which is at the same voltage as the
amplifier inputs, because no leakage current can flow between two points at the same potential. For example, a
PCB trace-to-pad resistance of 10¹² Ω, which is normally considered a very large resistance, could leak 5 pA if
the trace were a 5-V bus adjacent to the pad of the input. This would cause a 250 times degradation from the
actual performance of the LMC6482. However, if a guard ring is held within 5 mV of the inputs, then even a
resistance of 10¹¹ Ω would cause only 0.05 pA of leakage current. See Figure 79 through Figure 81 for typical
connections of guard rings for standard op-amp configurations.
The designer should be aware that when it is inappropriate to lay out a PCB for the sake of just a few circuits,
another technique is even better than a guard ring on a PCB: Do not insert the input pin of the amplifier into the
PCB at all, but bend it up in the air and use only air as an insulator. Air is an excellent insulator. In this case you
may have to forego some of the advantages of PCB construction, but the advantages are sometimes well worth
the effort of using point-to-point up-in-the-air wiring. See Figure 82.
10.2 Layout Example
Figure 78. Example of Guard Ring in PCB Layout Typical Connections of Guard Rings
28
Submit Documentation Feedback
Product Folder Links: LMC6482
Copyright © 1997–2015, Texas Instruments Incorporated