TCA6507_16 Datasheet, PDF (26/45 Pages) Texas Instruments – Low-Voltage 7-Bit I2C and SMBus LED Driver

TCA6507
SCPS164C – MAY 2007 – REVISED JANUARY 2016
www.ti.com
Table 19. One-Shot / Master Intensity Register (continued)
BIT
DESCRIPTION
Determines whether maximum intensity of PWM0 is set by the programmed F value or the master ALD value
4
0 = F value
1 = ALD value
Determines whether maximum intensity of PWM1 is set by the programmed F value or the master ALD value
5
0 = F value defined in Maximum Intensity per Bank Register (0x08)
1 = ALD value
Determines if PWM0 operates in normal or one-shot mode
6
0 = Normal mode
1 = One-shot mode
Determines if PWM1 operates in normal or one-shot mode
7
0 = Normal mode
1 = One-shot mode
8.6.8 Register 0x0A (Initialization Register)
The Initialization register (register 0x0A) determines whether to initialize each PWM and, if so, provides the
starting point of the LED intensity cycle for each bank. Bits 0–3 (C0–C3) are for BANK0 and bits 4–7 (C4–C7)
are for BANK1.
Bits 0–2 provide the starting point for PWM0. If bit 3 is high (or 1), it initializes PWM0.
Bits 4–6 provide the starting point for PWM1. If bit 7 is high (or 1), it initialized PWM1.
In the one-shot mode for BANK0, the LEDs start at the beginning of the region defined by C2, C1, and C0 in the
Initialization register and, when it reaches the end of that region, the LED stays at that intensity level defined at
the end of the region. When the stop point is reached, all P ports attached to PWM0 disconnect from PWM0, and
stay at either the maximum intensity level for PWM0 (BRIGHT_F0 or ALD value), or the OFF state. The bits in
the Select2 and Select1 registers change to reflect the final state of the LED at that time. PWM0 continues
running, and is free to be used by other LEDs. The one-shot mode works similarly for BANK1.
Upon writing to this register, each bank is initialized to the state listed in Table 21 and Table 22.
BANK
BIT
Table 20. Register 0x0A (Initialization Register)
BANK1
BANK0
C7
C6
C5
C4
C3
C2
C1
C0
Table 21. Bank 1 Initialization Register
C7
C6
C5
C4
INTENSITY CYCLE
1
0
0
0
Beginning at region A1 in Table 5 and Figure 18
1
0
0
1
Beginning at region B1 in Table 5 and Figure 18
1
0
1
0
Beginning at region C1 in Table 5 and Figure 18
1
0
1
1
Beginning at region D in Table 5 and Figure 18
1
1
0
0
Beginning at region A2 in Table 5 and Figure 18
1
1
0
1
Beginning at region B2 in Table 5 and Figure 18
1
1
1
0
Beginning at region C2 in Table 5 and Figure 18
1
1
1
1
Beginning at region E in Table 5 and Figure 18
26
Submit Documentation Feedback
Product Folder Links: TCA6507
Copyright © 2007–2016, Texas Instruments Incorporated