THS4531A Datasheet, PDF (23/51 Pages) Texas Instruments – Ultra Low Power, Rail-to-Rail Output, Fully-Differential Amplifier

www.ti.com
THS4531A
SLOS823A – DECEMBER 2012 – REVISED JANUARY 2013
APPLICATION INFORMATION
TYPICAL CHARACTERISTICS TEST CIRCUITS
Figure 68 shows the general test circuit built on the EVM that was used for testing the THS4531A. For simplicity,
power supply decoupling is not shown – please see layout in the applications section for recommendations.
Depending on the test conditions, component values are changed per Table 2 and Table 3, or as otherwise
noted. Some of the signal generators used are ac coupled 50Ω sources and a 0.22µF cap and 49.9Ω resistor to
ground are inserted across R_IT on the un-driven or alternate input as shown to balance the circuit. Split-power
supply is used to ease the interface to common lab test equipment, but if properly biased, the amplifier can be
operated single-supply as described in the applications section with no impact on performance. For most of the
tests, the devices are tested with single ended input and a transformer on the output to convert the differential
output to single ended because common lab test equipment have single ended inputs and outputs. Performance
is the same or better with differential input and differential output.
V_IN+
Input From 50-
Test Equipment
R_G
PD
R_IT
0.22 F
V_IN±
No Connection
Installed to Balance
Amplifier
0.22 F
49.9
0.22 F
R_G
R_IT
R_F
R_O
V_S+
V_OUT±
1:1
+
V_OCM THS4531A
R_OT
±
V_S±
V_OUT+
R_O
R_F
Output to 50-
Test Equipment
Figure 68. General Test Circuit
Table 2. Gain Component Values for Single-Ended Input⁽¹⁾
GAIN
R_F
1 V/V
2kΩ
2 V/V
2kΩ
5 V/V
2kΩ
10 V/V
2kΩ
R_G
2kΩ
1kΩ
392Ω
187kΩ
R_IT
51.1Ω
52.3Ω
53.6Ω
57.6Ω
(1) Note components are chosen to achieve gain and 50Ω input termination. Resistor values shown are closest standard values so gains
are approximate.
Table 3. Load Component Values For 1:1 Differential to Single-Ended Output Transformer⁽¹⁾
R_L
100Ω
200Ω
499Ω
1kΩ
2kΩ
R_O
25Ω
86.6Ω
237Ω
487Ω
976Ω
R_OT
open
69.8Ω
56.2Ω
52.3Ω
51.1Ω
ATTEN
6
16.8
25.5
31.8
37.9
(1) Note the total load includes 50Ω termination by the test equipment. Components are chosen to achieve load and 50Ω line termination
through a 1:1 transformer. Resistor values shown are closest standard values so loads are approximate.
Copyright © 2012–2013, Texas Instruments Incorporated
Product Folder Links :THS4531A
Submit Documentation Feedback
23