LT1013_16 Datasheet, PDF (20/36 Pages) Texas Instruments – Dual Precision Operational Amplifier

LT1013, LT1013D, LT1013M, LT1013AM
SLOS018I – MAY 1988 – REVISED JULY 2016
8 Application and Implementation
www.ti.com
NOTE
Information in the following applications sections is not part of the TI component
specification, and TI does not warrant its accuracy or completeness. TI’s customers are
responsible for determining suitability of components for their purposes. Customers should
validate and test their design implementation to confirm system functionality.
8.1 Application Information
The LT1013x operational amplifiers are useful in a wide range of signal conditioning applications where high DC
accuracy is needed.
8.2 Typical Application
A typical application for an operational amplifier in an inverting amplifier. This amplifier takes a positive voltage
on the input and makes it a negative voltage of the same magnitude. In the same manner, it also makes negative
voltages positive.
RF
RI
Vsup+
VOUT
+
VIN
Vsup-
Copyright © 2016, Texas Instruments Incorporated
Figure 27. Application Schematic
8.2.1 Design Requirements
The supply voltage must be chosen such that it is larger than the input voltage range and output range. For
instance, this application scales a signal of ±0.5 V to ±1.8 V. Setting the supply at ±12 V is sufficient to
accommodate this application.
8.2.2 Detailed Design Procedure
Determine the gain required by the inverting amplifier using Equation 1 and Equation 2:
(1)
(2)
Once the desired gain is determined, choose a value for RI or RF. Choosing a value in the kΩ range is desirable
because the amplifier circuit will use currents in the milliamp range. This ensures the part does not draw too
much current. This example chooses 10 kΩ for RI, which means 36 kΩ is used for RF. This was determined by
Equation 3.
(3)
20
Submit Documentation Feedback
Copyright © 1988–2016, Texas Instruments Incorporated
Product Folder Links: LT1013 LT1013D LT1013M LT1013AM