English
Language : 

OPA4313 Datasheet, PDF (2/38 Pages) Texas Instruments – 1-MHz, Micro-Power, Low-Noise, RRIO,1.8-V CMOS OPERATIONAL AMPLIFIER
◁
OPA313
OPA2313
OPA4313
SBOS649C – SEPTEMBER 2012 – REVISED MARCH 2013
www.ti.com
This integrated circuit can be damaged by ESD. Texas Instruments recommends that all integrated circuits be handled with
appropriate precautions. Failure to observe proper handling and installation procedures can cause damage.
ESD damage can range from subtle performance degradation to complete device failure. Precision integrated circuits may be more
susceptible to damage because very small parametric changes could cause the device not to meet its published specifications.
PRODUCT
OPA313
OPA2313
OPA4313
PACKAGE INFORMATION(1)
PACKAGE-LEAD
PACKAGE
DESIGNATOR
SPECIFIED
TEMPERATURE RANGE
SC70-5
DCK
–40°C to +125°C
SOT23-5
DBV
–40°C to +125°C
SO-8
D
–40°C to +125°C
MSOP-8
DGK
–40°C to +125°C
DFN-8
DRG
–40°C to +125°C
TSSOP-14
PW
–40°C to +125°C
PACKAGE MARKING
SIE
SIF
OP2313
OUSS
SDY
OPA4313
(1) For the most current package and ordering information, see the Package Option Addendum at the end of this document, or visit the
device product folder at www.ti.com.
ABSOLUTE MAXIMUM RATINGS(1)
Over operating free-air temperature range, unless otherwise noted.
Supply voltage
Signal input terminals
Output short-circuit(3)
Operating temperature, TA
Storage temperature, Tstg
Junction temperature, TJ
ESD rating
Voltage (2)
Current (2)
Human body model (HBM)
Charged device model (CDM)
Machine model (MM)
OPA313, OPA2313, OPA4313
7
(V–) – 0.5 to (V+) + 0.5
±10
Continuous
–40 to +150
–65 to +150
+150
4000
1000
200
UNIT
V
V
mA
mA
°C
°C
°C
V
V
V
(1) Stresses above these ratings may cause permanent damage. Exposure to absolute maximum conditions for extended periods may
degrade device reliability. These are stress ratings only, and functional operation of the device at these or any other conditions beyond
those specified is not supported.
(2) Input terminals are diode-clamped to the power-supply rails. Input signals that can swing more than 0.5 V beyond the supply rails should
be current limited to 10 mA or less.
(3) Short-circuit to ground, one amplifier per package.
2
Submit Documentation Feedback
Copyright © 2012–2013, Texas Instruments Incorporated
Product Folder Links: OPA313 OPA2313 OPA4313
 ▷