English
Language : 

HD3SS215_15 Datasheet, PDF (18/31 Pages) Texas Instruments – HD3SS215 6.0 Gbps HDMI DisplayPort 2:1/1:2 Differential Switch
HD3SS215, HD3SS215I
SLAS971C – MAY 2014 – REVISED AUGUST 2015
www.ti.com
9.2.2.2 Detailed Design Procedure
The HD3SS215 is designed to operate with a 3.3V power supply. Levels above those listed in the Absolute
Ratings table should not be used. If using a higher voltage system power supply, a voltage regulator can be used
to step down to 3.3V. Decoupling capacitors may be used to reduce noise and improve power supply integrity.
Pull-up resistors to 5V must be placed on the source side DDC clock and data lines according to the HDMI2.0
Standard. A weak pull down resistor should be placed on the source side HPD line. This is to ensure the source
can differentiate between when HPD is disconnected or at a high voltage level. The AUX_SEL and Dx_SEL
control pins should be set according to the application and desired muxing.
9.2.3 HDMI 2:1 Sink Application Using the RTQ Package
The HD3SS215 can be placed in applications needing to switch between two HDMI connectors and one Generic
HDMI sink.
AUX_SEL and Dx_SEL configured for A to C
Figure 7. HDMI 2:1 Sink Application Using the RTQ Package
10 Power Supply Recommendations
The HD3SS215 is designed to operate with a 3.3V power supply. Levels above those listed in the Absolute
Ratings table should not be used. If using a higher voltage system power supply, a voltage regulator can be used
to step down to 3.3V. Decoupling capacitors may be used to reduce noise and improve power supply integrity.
18
Submit Documentation Feedback
Product Folder Links: HD3SS215
Copyright © 2014–2015, Texas Instruments Incorporated