BQ24702_16 Datasheet, PDF (18/37 Pages) Texas Instruments – MULTICHEMISTRY BATTERY CHARGER CONTROLLER

bq24702
bq24703
SLUS553E – MAY 2003 – REVISED OCTOBER 2007
www.ti.com
The overall accuracy of the battery charge regulation voltage is a function of the bypassed 5-V reference voltage
tolerance as well as the tolerances on R1 and R2. The precision voltage reference has a 0.5% tolerance making
it suitable for the tight battery voltage requirements of Li-ion batteries. Tolerance resistors of 0.1% are
recommended for R1 and R2 as well as any resistors used to set BATSET.
The bq24702/bq24703 provides the capability of using an internal precision voltage reference through the use of
a multiplexing scheme, refer to Figure 4, on the BATSET pin. When BATSET voltage is less than 0.25 V, an
internal reference is switched in and the BATSET pin is switched out from the g_m amplifier input. When the
BATSET voltage is greater than 0.25 V, the BATSET pin voltage is switched in to the input of the g_m amplifier
and the voltage reference is switched out.
NOTE:
The minimum recommended BATSET is 1.0 V, if BATSET is used to set the voltage
loop.
VBAT
BATP
13
BATSET
9
gm AMPLIFIER
+
COMP
10
VBAT
0.25 V
VREF = 5 V
R1
BATP
13
R2
9
BATSET
0.25 V
1.25 V
(a) V_BATSET < 0.25 V
gm AMPLIFIER
+
COMP
10
1.196 V
(b) V_BATSET > 1 V
Figure 4. Battery Error Amplifier Input Multiplexing Scheme
UDG-00116
18
Submit Documentation Feedback
Copyright © 2003–2007, Texas Instruments Incorporated
Product Folder Link(s): bq24702 bq24703