AMC1306E05_17 Datasheet, PDF (18/40 Pages) Texas Instruments – Small, High-Precision, Reinforced Isolated Delta-Sigma Modulators with High CMTI

AMC1306E05, AMC1306E25, AMC1306M05, AMC1306M25
SBAS734 – MARCH 2017
www.ti.com
8.3 Feature Description
8.3.1 Analog Input
The AMC1306 incorporates front-end circuitry that contains a differential amplifier and a sampling stage, followed
by a ΔΣ modulator. The gain of the differential amplifier is set by internal precision resistors to a factor of 4 for
devices with a specified input voltage range of ±250 mV (this value is for the AMC1306x25), or to a factor of 20
in devices with a ±50-mV input voltage range (for the AMC1306x05), resulting in a differential input impedance of
4.9 kΩ (for the AMC1306x05) or 22 kΩ (for the AMC1306x25). For reduced offset and offset drift, the differential
amplifier is chopper-stabilized with the switching frequency set at f_CLKIN / 32. The switching frequency generates
a spur as shown in Figure 42.
0
-20
-40
-60
-80
-100
-120
-140
-160
0.1
1
10
100
1000
10000
Frequency (kHz)
D007
sinc³ filter, OSR = 2, f_CLKIN = 20 MHz, f_IN = 1 kHz
Figure 42. Quantization Noise Shaping
Consider the input impedance of the AMC1306 in designs with high-impedance signal sources that can cause
degradation of gain and offset specifications. The importance of this effect, however, depends on the desired
system performance. Additionally, the input bias current caused by the internal common-mode voltage at the
output of the differential amplifier is dependent on the actual amplitude of the input signal; see the Isolated
Voltage Sensing section for more details on reducing these effects.
There are two restrictions on the analog input signals (AINP and AINN). First, if the input voltage exceeds the
range AGND – 6 V to AVDD + 0.5 V, the input current must be limited to 10 mA because the device input
electrostatic discharge (ESD) diodes turn on. In addition, the linearity and noise performance of the device are
ensured only when the differential analog input voltage remains within the specified linear full-scale range (FSR),
that is ±250 mV (for the AMC1306x25) or ±50 mV (for the AMC1306x05), and within the specified input common-
mode range.
18
Submit Documentation Feedback
Copyright © 2017, Texas Instruments Incorporated
Product Folder Links: AMC1306E05 AMC1306E25 AMC1306M05 AMC1306M25