TMS570LS0714 Datasheet, PDF (17/159 Pages) Texas Instruments – 16- and 32-Bit RISC Flash Microcontroller

www.ti.com
TMS570LS0714
SPNS226D – JUNE 2013 – REVISED SEPTEMBER 2015
4.2.1.6 General-Purpose Input / Output (GIO)
Table 4-6. PGE General-Purpose Input / Output (GIO)
Terminal
Signal Name
Signal Reset Pull
144 PGE ^{Type State}
Pull Type
Description
GIOA[0]
2
GIOA[1]
5
GIOA[2]/N2HET2[0]/EQEPII
9
GIOA[5]/EXTCLKIN1/EPWM1A/N2HET1_PIN_nDIS
GIOA[6]/N2HET2[4]/EPWM1B
GIOA[7]/N2HET2[6]/EPWM2A
GIOB[0]
GIOB[1]
14
General-purpose I/O.
16
Pulldown
All GIO terminals are
22
I/O
Programmable, capable of generating
20 µA
interrupts to the CPU
126
on rising / falling /
133
both edges.
GIOB[2]
MIBSPI3NCS[0]/AD2EVT/GIOB[2]/EQEP1I/N2HET2_PIN_nDIS
142
55 ⁽¹⁾
Pullup
GIOB[3]
1
Pulldown
(1) GIOB[2] cannot output a level on to pin 55. Only the input functionality is supported so that the application can generate an interrupt
whenever the N2HET2_PIN_nDIS is asserted (driven low). Also, a pullup is enabled on the input. This is not programmable using the
GIO module control registers.
4.2.1.7 Controller Area Network Controllers (DCAN)
CAN1RX
CAN1TX
CAN2RX
CAN2TX
CAN3RX
CAN3TX
Table 4-7. PGE Controller Area Network Controllers (DCAN)
Terminal
Signal Name
144
PGE
A
90
89
129
128
12
13
Signal Reset Pull
Type
State
Pull Type
Description
I/O
Pullup Programmable, CAN1 receive, or GIO
20 µA
CAN1 transmit, or GIO
CAN2 receive, or GIO
CAN2 transmit, or GIO
CAN3 receive, or GIO
CAN3 transmit, or GIO
4.2.1.8 Local Interconnect Network Interface Module (LIN)
LINRX
LINTX
Table 4-8. PGE Local Interconnect Network Interface Module (LIN)
Terminal
Signal Name
144
PGE
131
132
Signal Reset Pull
Type
State
Pull Type
Description
I/O
Pullup Programmable, LIN receive, or GIO
20 µA
LIN transmit, or GIO
Copyright © 2013–2015, Texas Instruments Incorporated
Terminal Configuration and Functions
17
Submit Documentation Feedback
Product Folder Links: TMS570LS0714