BQ2000T_15 Datasheet, PDF (15/29 Pages) Texas Instruments – Programmable Multi-Chemistry Fast-Charge Management IC

bq2000T
www.ti.com
SLUS149D – MAY 1999 – REVISED JANUARY 2010
Table 5. Summary of Li-Ion Charging Characteristics
PARAMETER
VALUE ⁽¹⁾
Maximum cell voltage (V_MCV)
Minimum pre-charge qualification voltage (V_LBAT)
High-temperature cutoff voltage (V_TCO)
High-temperature fault voltage (V_HTF)
Low-temperature fault voltage (V_LTF)
bq2000T fast-charge maximum time out (MTO)
2V
950 mV
0.225 × V_CC
0.25 × V_CC
0.5 × V_CC
2 × R_MTO × C_MTO × 35,988
(See Maximum Charge Time section for full explanation)
Fast-charge charging current (I_MAX)
Hold-off period
0.05/R_SNS
MTO/32
Minimum current (for fast-charge termination)
Trickle-charge frequency (before fast charge only)
I_MAX/14
1 Hz
Trickle-charge pulse-width (before fast charge only)
See Figure 7
(1) See the DC Thresholds Specification for details.
Charge Status Display
The charge status is indicated by open-drain output LED. Table 6 summarizes the display output of the bq2000T.
A temperature fault or timer expiring changes the charge state immediately (according to Figure 2) and thus
changes the LED status immediately and accordingly.
Table 6. Charge Status Display
bq2000T CHARGE STATE
Charge qualification (including battery conditioning and charge suspended)
Fast charge (current and voltage regulation)
Top-off charge
Trickle maintenance charge (after fast charge)
Charge complete
Battery absent
Sleep mode
LED STATUS
1-Hz flash
Low
High impedance
Sleep Mode
The bq2000T features a sleep mode for low power consumption. This mode is enabled when the voltage at the
BAT pin is above the low-power-mode threshold, V_SLP. During sleep mode, the bq2000T shuts down all
unnecessary internal circuits, drives the LED output to high-impedance state, and drives the MOD pin low.
Restoring BAT below the V_MCV threshold initiates the IC and starts a fast-charge cycle. Normally, the bq2000T
only enters sleep mode when there is no battery connected on the output and the charger is idling with nothing to
charge. In addition, V_IN needs to be high enough such that when V_IN is present on the output, V_BAT would be
greater than V_SLP. In sleep mode, the output voltage decays to V_MCV at which point the bq2000T turns on and
pulses the MOD pin several times. With no battery connected, the output rises to near V_IN at which point the
bq2000T re-enters sleep mode. During sleep mode, the RC pin is at V_SS potential. A typical sleep mode
waveform is shown in Figure 18.
Copyright © 1999–2010, Texas Instruments Incorporated
Product Folder Link(s): bq2000T
Submit Documentation Feedback
15