 English |
|
|
|
|
|
|
|
| LP2981-N Datasheet, PDF (14/24 Pages) Texas Instruments – Micropower 100 mA Ultra Low-Dropout Regulator in SOT-23 Package | |||
| |||
| ◁ |
LP2981-N
SNOS773K â MARCH 2000 â REVISED APRIL 2013
www.ti.com
ON/OFF INPUT OPERATION
The LP2981-N is shut off by pulling the ON/OFF input low, and turned on by driving the input high. If this feature
is not to be used, the ON/OFF input should be tied to VIN to keep the regulator on at all times (the ON/OFF input
must not be left floating).
To ensure proper operation, the signal source used to drive the ON/OFF input must be able to swing above and
below the specified turn-on/turn-off voltage thresholds which specify an ON or OFF state (see ELECTRICAL
CHARACTERISTICS).
The ON/OFF signal may come from either a totem-pole output, or an open-collector output with pull-up resistor to
the LP2981-N input voltage or another logic supply. The high-level voltage may exceed the LP2981-N input
voltage, but must remain within the Absolute Maximum Ratings for the ON/OFF pin.
It is also important that the turn-on/turn-off voltage signals applied to the ON/OFF input have a slew rate which is
greater than 40 mV/μs.
NOTE
IMPORTANT: The regulator shutdown function will not operate correctly if a slow-moving
signal is applied to the ON/OFF input.
14
Submit Documentation Feedback
Product Folder Links: LP2981-N
Copyright © 2000â2013, Texas Instruments Incorporated
|
▷ |
German
Russian
Spanish
Italian
Polish
Chinese
Japanese
Korean
French
Portuguese