TUSB1210 Datasheet, PDF (1/66 Pages) Texas Instruments – TUSB1210 Stand-Alone USB Transceiver Chip Silicon

Product
Folder
Sample &
Buy
Technical
Documents
Tools &
Software
Support &
Community
TUSB1210
SLLSE09H – NOVEMBER 2009 – REVISED JUNE 2015
TUSB1210 Stand-Alone USB Transceiver Chip Silicon
1 Device Overview
1.1 Features
1
• USB2.0 PHY Transceiver Chip, Designed to
Interface With a USB Controller Through a ULPI
Interface, Fully Compliant With:
– Universal Serial Bus Specification Rev. 2.0
– On-The-Go Supplement to the USB 2.0
Specification Rev. 1.3
– UTMI+ Low Pin Interface (ULPI) Specification
Rev. 1.1
– ULPI 12-pin SDR Interface
• DP/DM Line External Component Compensation
(Patent #US7965100 B1)
• Interfaces to Host, Peripheral and OTG Device
Cores; Optimized for Portable Devices or System
ASICs With Built-in USB OTG Device Core
• Complete USB OTG Physical Front-End That
Supports Host Negotiation Protocol (HNP) and
Session Request Protocol (SRP)
• V_BUS Overvoltage Protection Circuitry Protects
V_BUS Pin in Range –2 V to 20 V
• Internal 5-V Short-Circuit Protection of DP, DM,
and ID Pins for Cable Shorting to V_BUS Pin
• ULPI Interface:
– I/O Interface (1.8 V) Optimized for
Nonterminated 50-Ω Line Impedance
– ULPI CLOCK Pin (60 MHz) Supports Both Input
and Output Clock Configurations
– Fully Programmable ULPI-Compliant Register
Set
• Full Industrial Grade Operating Temperature
Range From –40°C to 85°C
• Available in a 32-Pin Quad Flat No Lead [QFN
(RHB)] Package
1.2 Applications
• Mobile Phones
• Portable Computers
• Tablet Devices
• Video Game Consoles
• Desktop Computers
• Portable Music Players
1.3 Description
The TUSB1210 is a USB2.0 transceiver chip, designed to interface with a USB controller through a ULPI
interface. The device supports all USB2.0 data rates (high-speed 480 Mbps, full-speed 12 Mbps, and low-
speed 1.5 Mbps), and is compliant to both host and peripheral modes. The device additionally supports a
UART mode and legacy ULPI serial modes. TUSB1210 also supports the OTG (Ver1.3) optional
addendum to the USB 2.0 Specification, including HNP and SRP.
The DP/DM external component compensation in the transmitter compensates for variations in the series
impendence in order to match with the data line impedance and the receiver input impedance, to limit data
reflections and thereby improve eye diagrams.
PART NUMBER
Device Information⁽¹⁾
PACKAGE
BODY SIZE (NOM)
TUSB1210
VQFN (32)
5.00 mm x 5.00 mm
(1) For more information, see Section 8, Mechanical Packaging and Orderable Information.
1
An IMPORTANT NOTICE at the end of this data sheet addresses availability, warranty, changes, use in safety-critical applications,
intellectual property matters and other important disclaimers. PRODUCTION DATA.