TLV320AIC3111 Datasheet, PDF (67/156 Pages) Texas Instruments – Low-Power Audio Codec With Embedded miniDSP and Stereo Class-D Speaker Amplifier

TLV320AIC3111
www.ti.com
SLAS644B – JULY 2009 – REVISED OCTOBER 2009
Divider
NDAC
MDAC
DOSR
NADC
MADC
AOSR
Table 5-40. CODEC CLKIN Clock Dividers
Bits
Page 0 / register 11, bits D6–D0
Page 0 / register 12, bits D6–D0
Page 0 / register 13, bits D1–D0 and page 0 / register 14, bits D7–D0
Page 0 / register 18, bits D6–D0
Page 0 / register 19, bits D6–D0
Page 0 / register 20, bits D7–D0
The DAC modulator is clocked by DAC_MOD_CLK. For proper power-up operation of the DAC channel,
DAC_MOD_CLK must be enabled by configuring the NDAC and MDAC clock dividers (page 0 /
register 11, bit D7 = 1 and page 0 / register 12, bit D7 = 1). When the DAC channel is powered down, the
device internally initiates a power-down sequence for proper shutdown. During this shutdown sequence,
the NDAC and MDAC dividers must not be powered down, or else a proper low-power shutdown may not
take place. The user can read back the power-status flag at page 0 / register 37, bit D7 and page 0 /
register 37, bit D3. When both the flags indicate power-down, the MDAC divider may be powered down,
followed by the NDAC divider. Note that when the ADC clock dividers are powered down, the ADC clock
is derived from the DAC clocks.
The ADC modulator is clocked by ADC_MOD_CLK. For proper power-up of the ADC channel, these
clocks are enabled by the NADC and MADC clock dividers (page 0 / register 18, bit D7 = 1 and page 0 /
register 19, bit D7 = 1). When the ADC channel is powered down, the device internally initiates a
power-down sequence for proper shutdown. During this shutdown sequence, the NADC and MADC
dividers must not be powered down, or else a proper low-power shutdown may not take place. The user
can read back the power-status flag from page 0 / register 36, bit D6. When this flag indicates power
down, the MADC divider may be powered down, followed by NADC divider.
When ADC_CLK (ADC DSP clock) is derived from the NDAC divider output, the NDAC must be kept
powered up until the power-down status flags for ADC do not indicate power down. When the input to the
AOSR clock divider is derived from DAC_MOD_CLK, then MDAC must be powered up when ADC_f_S is
needed (i.e., when WCLK is generated by the TLV320AIC3111 or AGC is enabled) and can be powered
down only after the ADC power-down flags indicate power-down status.
In general, for proper operation, all the root clock dividers should be powered down only after the child
clock dividers have been powered down.
The TLV320AIC3111 also has options for routing some of the internal clocks to the output pins of the
device to be used as general-purpose clocks in the system. The feature is shown in Figure 5-38.
Copyright © 2009, Texas Instruments Incorporated
Submit Documentation Feedback
Product Folder Link(s): TLV320AIC3111
APPLICATION INFORMATION
67