TLE207XA Datasheet, PDF (6/81 Pages) Texas Instruments – EXCALIBUR LOW-NOISE HIGH-SPEED JFET-INPUT OPERATIONAL AMPLIFIERS

TLE207x, TLE207xA
ą
EXCALIBUR LOWĆNOISE HIGHĆSPEED
JFETĆINPUT OPERATIONAL AMPLIFIERS
SLOS181B − FEBRUARY 1997 − REVISED APRIL 2004
absolute maximum ratings over operating free-air temperature range (unless otherwise noted)^†
Supply voltage, V_{CC +} (see Note 1) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19 V
Supply voltage, V_{CC −} (see Note 1) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . −19 V
Differential input voltage range, V_ID (see Note 2) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . V_{CC +} to V_{CC −}
Input voltage range, V_I (any input) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . V_{CC +} to V_{CC −}
Input current, I_I (each input) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ± 1 mA
Output current, I_O (each output) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ± 80 mA
Total current into V_{CC +} . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 160 mA
Total current out of V_{CC −} . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 160 mA
Duration of short-circuit current at (or below) 25°C (see Note 3) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . unlimited
Package thermal impedance, θ_JA (see Notes 4 and 5): D package . . . . . . . . . . . . . . . . . . . . . . . . . . 97.1°C/W
DW package . . . . . . . . . . . . . . . . . . . . . . . . 57.3°C/W
N package . . . . . . . . . . . . . . . . . . . . . . . . . . 79.7°C/W
P package . . . . . . . . . . . . . . . . . . . . . . . . . . 84.6°C/W
Package thermal impedance, θ_JC (see Notes 4 and 5): FK package . . . . . . . . . . . . . . . . . . . . . . . . . . . 5.6°C/W
J package . . . . . . . . . . . . . . . . . . . . . . . . . . 15.1°C/W
JG package . . . . . . . . . . . . . . . . . . . . . . . . . 14.5°C/W
U package . . . . . . . . . . . . . . . . . . . . . . . . . . 14.7°C/W
W package . . . . . . . . . . . . . . . . . . . . . . . . . . . 10°C/W
Operating free-air temperature range, T_A: C suffix . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0°C to 70°C
I suffix . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . −40°C to 85°C
M suffix . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . −55°C to 125°C
Storage temperature range . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . −65°C to 150°C
Case temperature for 60 seconds: FK package . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 260°C
Lead temperature 1,6 mm (1/16 inch) from case for 10 seconds: DW or N package . . . . . . . . . . . . . . . 260°C
Lead temperature 1,6 mm (1/16 inch) from case for 60 seconds: J, JG, U, or W package . . . . . . . . . . 300°C
† _{Stresses beyond those listed under “absolute maximum ratings” may cause permanent damage to the device. These are stress ratings only, and}
functional operation of the device at these or any other conditions beyond those indicated under “recommended operating conditions” is not
implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
NOTES: 1. All voltage values, except differential voltages, are with respect to the midpoint between VCC ₊ and VCC _−.
2. Differential voltages are at the noninverting input with respect to the inverting input.
3. The output may be shorted to either supply. Temperatures and/or supply voltages must be limited to ensure that the maximum
dissipation rate is not exceeded.
4. Maximum power dissipation is a function of TJ(max), θ_JA, and TA. The maximum allowable power dissipation at any allowable
ambient temperature is PD = (TJ(max) − TA)/θ_JA. Operating at the absolute maximum TJ of 150°C can affect reliability.
5. The package thermal impedance is calculated in accordance with JESD 51-7 (plastic) or MIL-STD-883 Method 1012 (ceramic).
recommended operating conditions
Supply voltage, VCC_±
Common-mode input voltage, VIC
Operating free-air temperature, TA
VCC _± = ± 5 V
VCC _± = ±15 V
C SUFFIX
I SUFFIX
M SUFFIX
MIN MAX MIN MAX MIN MAX
± 2.25 ± 19 ± 2.25 ± 19 ± 2.25 ± 19
− 0.9
5 −0.8
5 −0.8
5
−10.9 15 −10.8 15 −10.8 15
0
70 −40
85 −55 125
UNIT
V
V
°C
6
• POST OFFICE BOX 655303 DALLAS, TEXAS 75265