|
SN74ALVC7804_07 Datasheet, PDF (6/13 Pages) Texas Instruments – 512 × 18 FIRST-IN, FIRST-OUT MEMORY | |||
|
◁ |
SN74ALVC7804
512 Ã 18
FIRST-IN, FIRST-OUT MEMORY
SCAS432 â JANUARY 1995
absolute maximum ratings over operating free-air temperature range (unless otherwise noted)â
Supply voltage range, VCC . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . â 0.5 V to 4.6 V
Input voltage range, VI (see Note 1) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . â0.5 V to 4.6 V
Output voltage range, VO (see Notes 1 and 2) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . â0.5 V to VCC + 0.5 V
* Input clamp current, IIK (VI < 0) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 50 mA
" Output clamp current, IOK (VO < 0 or VO > VCC) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 50 mA
" Continuous output current, IO (VO = 0 to VCC) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 50 mA
" Continuous current through VCC or GND . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 100 mA
Voltage applied to a disabled 3-state output . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3.6 V
Operating free-air temperature range, TA . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0°C to 70°C
Storage temperature range . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . â 65°C to 150°C
â Stresses beyond those listed under âabsolute maximum ratingsâ may cause permanent damage to the device. These are stress ratings only, and
functional operation of the device at these or any other conditions beyond those indicated under ârecommended operating conditionsâ is not
implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
NOTES: 1. The input and output voltage ratings can be exceeded if the input and output clamp current ratings are observed.
2. This value is limited to 4.6 V maximum.
recommended operating conditions
VIH
VIL
VI
VO
IOH
IOL
fclock
High-level input voltage
Low-level input voltage
High-level output current,
Q outputs, Flags
Low-level output current,
Q outputs, Flags
Clock frequency
tw
Pulse duration
tsu
Setup time
th
Hold time
TA
Operating free-air temperature
VCC = 3 V
VCC = 3 V
D0 â D17 high or low
LDCK high or low
UNCK high or low
PEN low
RESET low
D0 â D17 before LDCKâ
LDCK inactive before RESET high
PEN before LDCKâ
D0 â D17 after LDCKâ
PEN high after LDCK low
PEN low after LDCKâ
LDCK inactive after RESET high
" â²ALVC7804-25
VCC = 3.3 V 0.3 V
MIN MAX
2
0.8
0 VCC
0 VCC
" â²ALVC7804-40
VCC = 3.3 V 0.3 V
MIN MAX
2
0.8
0 VCC
0 VCC
â8
â8
16
40
8
8
8
8
10
5
6
8
0
0
3
6
0
70
16
25
12
12
12
12
12
5
6
8
0
0
3
6
0
70
UNIT
V
V
V
V
mA
mA
MHz
ns
ns
ns
°C
6
⢠POST OFFICE BOX 655303 DALLAS, TEXAS 75265
|
▷ |