DS14C335MSAX Datasheet, PDF (6/16 Pages) Texas Instruments – DS14C335 3.3V Supply TIA/EIA-232 3 x 5 Driver/Receiver

DS14C335
SNLS090C – MARCH 2000 – REVISED APRIL 2013
www.ti.com
Figure 8. Receiver SHUTDOWN (SD) Delay Test Circuit
Figure 9. Receiver SHUTDOWN (SD) Delay Timing
PIN DESCRIPTIONS
V_CC (Pin 3). Power supply pin for the device, +3.3V (±0.3V).
V+ (Pin 1). Positive supply for TIA/EIA-232-E drivers. Recommended external capacitor—0.47 μF (16V). This supply is not intended to be
loaded externally.
V− (Pin 25). Negative supply for TIA/EIA-232-E drivers. Recommended external capacitor—0.47 μF (16V). This supply is not intended to be
loaded externally.
C1+, C1− (Pins 6, 24). External capacitor connection pins. Recommended capacitor—0.47 μF (6.3V).
C2+, C2− (Pins 2, 4). External capacitor connection pins. Recommended capacitor—0.47 μF (16V).
C3+, C3− (Pins 28, 26). External capacitor connection pins. Recommended capacitor—0.47 μF (6.3V).
SHUTDOWN (SD) (Pin 23). A High on the SHUTDOWN pin will lower the total I_CC current to less than 10 μA, providing a low power state.
In this mode receiver R5 remains active. The SD pin should be driven or tied low (GND) to disable the shutdown mode.
D_IN 1–3 (Pins 7, 8, 9). Driver input pins are JEDEC 3.3V standard compatible.
D_OUT 1–3 (Pins 22, 21, 20). Driver output pins conform to TIA/ElA-232 -E levels.
R_IN 1–5 (Pins 19, 18, 17, 16, 15). Receiver input pins accept TIA/EIA-232-E input voltages (±25V). Receivers specifies hysteresis of TBD
mV. Unused receiver input pins may be left open. Internal input resistor (5 kΩ) pulls input LOW, providing a failsafe HIGH output.
R_OUT 1–5 (Pins 10, 11, 12, 13, 14). Receiver output pins are JEDEC 3.3V standard compatible.
GND (Pin 27). Ground Pin.
6
Submit Documentation Feedback
Product Folder Links: DS14C335
Copyright © 2000–2013, Texas Instruments Incorporated