English
Language : 

TS3V330_10 Datasheet, PDF (5/26 Pages) Texas Instruments – QUAD SPDT WIDE-BANDWIDTH VIDEO SWITCH WITH LOW ON-STATE RESISTANCE
◁
www.ti.com
TS3V330
QUAD SPDT WIDE-BANDWIDTH VIDEO SWITCH
WITH LOW ON-STATE RESISTANCE
SCDS162C – MAY 2004 – REVISED JULY 2005
Absolute Maximum Ratings(1)
over operating free-air temperature range (unless otherwise noted)
VCC
Supply voltage range
VIN
Control input voltage range(2)(3)
VI/O
Switch I/O voltage range(2)(3)(4)
IIK
Control input clamp current
II/OK
I/O port clamp current
II/O
ON-state switch current(5)
Continuous current through VCC or GND
θJA
Package thermal impedance
Tstg
Storage temperature range
VIN < 0
VI/O < 0
D package(6)
DBQ package(6)
DGV package
PW package(6)
RGY package(7)
MIN MAX UNIT
–0.5
4.6 V
–0.5
4.6 V
–0.5
4.6 V
–50 mA
–50 mA
±128 mA
±100 mA
73
90
120 C/W
108
39
–65
150 C
(1) Stresses beyond those listed under "absolute maximum ratings" may cause permanent damage to the device. These are stress ratings
only, and functional operation of the device at these or any other conditions beyond those indicated under "recommended operating
conditions" is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
(2) All voltages are with respect to ground, unless otherwise specified.
(3) The input and output voltage ratings may be exceeded if the input and output clamp-current ratings are observed.
(4) VI and VO are used to denote specific conditions for VI/O.
(5) II and IO are used to denote specific conditions for II/O.
(6) The package thermal impedance is calculated in accordance with JESD 51-7.
(7) The package thermal impedance is calculated in accordance with JESD 51-5.
Recommended Operating Conditions(1)
VCC
VIH
VIL
VANALOG
TA
Supply voltage
High-level control input voltage (EN, IN)
Low-level control input voltage (EN, IN)
Analog I/O voltage
Operating free-air temperature
MIN MAX UNIT
3 3.6 V
2 VCC
V
0 0.8 V
0 VCC
V
–40
85 °C
(1) All unused control inputs of the device must be held at VCC or GND to ensure proper device operation. Refer to the TI application report,
Implications of Slow or Floating CMOS Inputs, literature number SCBA004.
5
 ▷