TL3016CDR Datasheet, PDF (5/17 Pages) Texas Instruments – ULTRA-FAST LOW-POWER PRECISION COMPARATORS

TL3016, TL3016Y
ULTRA-FAST LOW-POWER
PRECISION COMPARATORS
SLCS130D – MARCH 1997 – REVISED MARCH 2000
switching characteristics, V_DD = ±5 V, V_LE = 0 (unless otherwise noted)
PARAMETER
TEST CONDITIONS†
TL3016C
TL3016I
UNIT
MIN TYP MAX MIN TYP MAX
tpd1
Propagation delay time‡
∆VI = 100 mV,
VOD = 5 mV
∆VI = 100 mV,
VOD = 20 mV
TA = 25°C
TA = full range
TA = 25°C
TA = full range
7.8
10
7.8 11.2
7.6
10
7.6 11.2
7.8
10
7.8 12.2
ns
7.6
10
7.6 12.2
tsk(p) Pulse skew (|tpd+ – tpd–|)
∆VI = 100 mV, VOD = 5 mV,
TA = 25°C
0.5
0.5
ns
tsu
Setup time, LATCH ENABLE
2.5
2.5
ns
† _{Full range for the TL3016C is 0°C to 70°C. Full range for the TL3016I is – 40°C to 85°C.}
‡ _{tpd1 cannot be measured in automatic handling equipment with low values of overdrive. The TL3016 is 100% tested with a 1-V step and 500-mV}
overdrive at TA = 25°C only. Correlation tests have shown that tpd1 limits given can be ensured with this test, if additional dc tests are performed
to ensure that all internal bias conditions are correct. For low overdrive conditions, VOS is added to the overdrive.
TYPICAL CHARACTERISTICS
Table of Graphs
vs Input voltage
ICC
Positive supply current
vs Frequency
vs Free-air temperature
ICC
Negative supply current
vs Free-air temperature
vs Overdrive voltage
vs Supply voltage
tpd
Propagation delay time
vs Input impedance
vs Load capacitance
vs Free-air temperature
VIC
Common-mode input voltage
vs Free-air temperature
Input threshold voltage (LATCH ENABLE) vs Free-air temperature
VO
Output voltage
vs Output source current
vs Output sink current
II
Input current (LATCH ENABLE)
vs Input voltage
FIGURE
2
3
4
5
6
7
8
9
10
11
12
13
14
15
• POST OFFICE BOX 655303 DALLAS, TEXAS 75265
5