TIL311_1 Datasheet, PDF (4/5 Pages) Texas Instruments – HEXADECIMAL DISPLAY WITH LOGIC

TIL311
HEXADECIMAL DISPLAY WITH LOGIC
SODS001D – MARCH 1972 – REVISED DECEMBER 1997
operating characteristics at T_A = 25°C
PARAMETER
TEST CONDITIONS
MIN TYP MAX UNIT
Iv
Luminous intensity (see Note 3)
Average per
character LED
VCC = 5 V,
See Note 4
VLED = 5 V,
35 100
µcd
Each decimal
IF(DP) = 5 mA
35 100
µcd
λ_p Wavelength at peak emission
∆λ Spectral bandwidth
VCC = 5 V,
VLED = 5 V,
IF(DP) = 5 mA, See Note 5
660
nm
20
nm
VIH High-level ilnput voltage
2
V
VIL Low-level input voltage
0.8 V
VIK Input clamp voltage
VCC = 4.75 V, II = – 12 mA
– 1.5 V
II
Input current
VCC = 5.5 V , VI = 5.5 V
1 mA
IIH High-level input current
VCC = 5.5 V , VI = 2.4 V
40 µA
IIL Low-level input current
VCC = 5.5 V , VI = 0.4 V
– 1.6 mA
ICC Supply current, logic
ILED Supply current, LED
VCC = 5.5 V , VLED = 5.5 V,
IF(DP) = 5 mA, All inputs at 0 V
60
90 mA
45
90 mA
NOTES: 3. Luminous intensity is measured with a light sensor and filter combination that approximates the CIE (International Commission on
Illumination) eye-response curve.
4. This parameter is measured with displayed, then again with
displayed.
5. These parameters are measured with displayed.
TYPICAL CHARACTERISTICS
RELATIVE SPECTRAL CHARACTERISTIC
1
0.9
VCC = 5 V
TC = 25°C
0.8
0.7
0.6
0.5
0.4
0.3
0.2
0.1
0
600 610 620 630 640 650 660 670 680 690 700
λ – Wavelength – nm
Figure 1
4
• POST OFFICE BOX 655303 DALLAS, TEXAS 75265
• POST OFFICE BOX 1443 HOUSTON, TEXAS 77251–1443