SN74CBTLV3383 Datasheet, PDF (4/6 Pages) Texas Instruments – LOW-VOLTAGE 10-BIT FET BUS-EXCHANGE SWITCH

SN74CBTLV3383
LOW-VOLTAGE 10-BIT FET BUS-EXCHANGE SWITCH
SCDS047D – MARCH 1998 – REVISED NOVEMBER 1999
switching characteristics over recommended operating free-air temperature range (unless
otherwise noted) (see Figures 1 and 2)
PARAMETER
FROM
(INPUT)
TO
(OUTPUT)
VCC = 2.5 V
± 0.2 V
MIN MAX
VCC = 3.3 V
± 0.3 V
MIN MAX
UNIT
tpd†
A or B
B or A
0.15
0.25 ns
tpd
BX
A or B
1.5 5.8 1.5 4.7 ns
ten
BE
A or B
1.5 5.3 1.5 4.7 ns
tdis
BE
A or B
1
6
1
6 ns
† _{The propagation delay is the calculated RC time constant of the typical on-state resistance of the switch and the specified load capacitance when}
driven by an ideal voltage source (zero output impedance).
PARAMETER MEASUREMENT INFORMATION
V_CC = 2.5 V ± 0.2 V
From Output
Under Test
CL = 30 pF
(see Note A)
500 Ω ^S1
500 Ω
2 × VCC
Open
GND
TEST
tpd
tPLZ/tPZL
tPHZ/tPZH
S1
Open
2 × VCC
GND
LOAD CIRCUIT
Output
Control
(low-level
enabling)
VCC/2
VCC/2
VCC
0V
Input
VCC/2
VCC/2
VCC
0V
tPLH
Output
VCC/2
VOLTAGE WAVEFORMS
PROPAGATION DELAY TIMES
tPHL
VOH
VCC/2
VOL
tPZL
Output
Waveform 1
S1 at 2 × VCC
(see Note B)
VCC/2
tPLZ
VCC
VOL + 0.15 V
VOL
tPZH
Output
Waveform 2
S1 at GND
(see Note B)
VCC/2
tPHZ
VOH
VOH – 0.15 V
0V
VOLTAGE WAVEFORMS
ENABLE AND DISABLE TIMES
NOTES: A. CL includes probe and jig capacitance.
B. Waveform 1 is for an output with internal conditions such that the output is low except when disabled by the output control.
Waveform 2 is for an output with internal conditions such that the output is high except when disabled by the output control.
C. All input pulses are supplied by generators having the following characteristics: PRR ≤ 10 MHz, ZO = 50 Ω, tr ≤ 2 ns, tf ≤ 2 ns.
D. The outputs are measured one at a time with one transition per measurement.
E. tPLZ and tPHZ are the same as tdis.
F. tPZL and tPZH are the same as ten.
G. tPLH and tPHL are the same as tpd.
Figure 1. Load Circuit and Voltage Waveforms
4
• POST OFFICE BOX 655303 DALLAS, TEXAS 75265