LP38501TJ-ADJ Datasheet, PDF (4/18 Pages) Texas Instruments – LP38501/3-ADJ, LP38501A/3A-ADJ 3A FlexCap Low Dropout Linear Regulator

Pin Descriptions for TO-263 (TS) and TO-263 THIN (TJ) Packages
Pin #
1
2
3
4
5
DAP
Designation
EN
N/C
IN
GND
OUT
ADJ
DAP
Function
Enable (LP38501 only). Pull high to enable the output, low to disable the output. This pin has
no internal bias and must be either tied to the input voltage, or actively driven.
In the LP38503, this pin has no internal connections. It can be left floating or used for trace
routing.
Input Supply Pin
Ground
Regulated Output Voltage Pin
Sets output voltage
The DAP is used as a thermal connection to remove heat from the device to the circuit board
copper clad area which acts as the heatsink. The DAP is electrically connected to the
backside of the die. The DAP must be connected to ground potential, but can not be used as
the only ground connection.
Ordering Information
TABLE 1. Package Marking and Ordering Information
Output
Voltage
ADJ
ADJ
Order Number
LP38501TSX-ADJ
LP38501TS-ADJ
LP38503TSX-ADJ
LP38503TS-ADJ
LP38501TJ-ADJ
LP38503TJ-ADJ
LP38501ATJ-ADJ
LP38503ATJ-ADJ
Package Type
TO-263
TO-263 THIN
Package Marking
LP38501TS-ADJ
LP38501TS-ADJ
LP38503TS-ADJ
LP38503TS-ADJ
LP38501TJ-ADJ
LP38503TJ-ADJ
LP38501ATJ-AD
LP38503ATJ-AD
Supplied As:
Tape and Reel of 500 Units
Rail of 45 Units
Tape and Reel of 500 Units
Rail of 45 Units
Tape and Reel of 1000 Units
Tape and Reel of 1000 Units
Tape and Reel of 1000 Units
Tape and Reel of 1000 Units
3
www.national.com