OPA2192 Datasheet, PDF (33/51 Pages) Texas Instruments – OPAx192 36-V, Precision, Rail-to-Rail Input/Output, Low Offset Voltage,Low Input Bias Current Op Amp with e-trim

www.ti.com
OPA192, OPA2192, OPA4192
SBOS620D – DECEMBER 2013 – REVISED SEPTEMBER 2015
9.2.2 Slew Rate Limit for Input Protection
In control systems for valves or motors, abrupt changes in voltages or currents can cause mechanical damages.
By controlling the slew rate of the command voltages into the drive circuits, the load voltages ramps up and down
at a safe rate. For symmetrical slew-rate applications (positive slew rate equals negative slew rate), one
additional op amp provides slew-rate control for a given analog gain stage. The unique input protection and high
output current and slew rate of the OPAx192 make the device an optimal amplifier to achieve slew rate control
for both dual- and single-supply systems.Figure 68 shows the OPA192 in a slew-rate limit design.
Op Amp Gain Stage
VEE

VIN
OPA192
 ^V+
VCC
Slew Rate Limiter
R2
1.6 MŸ
C1
470 nF
R1
1.69 kŸ
VEE

OPA192
 ^V+
VCC
VOUT
RL
10 kŸ
Figure 68. Slew Rate Limiter Uses One Op Amp
For step-by-step design procedure, circuit schematics, bill of materials, PCB files, simulation results, and test
results, refer to TI Precision Design TIDU026, Slew Rate Limiter Uses One Op Amp.
Copyright © 2013–2015, Texas Instruments Incorporated
Submit Documentation Feedback
33
Product Folder Links: OPA192 OPA2192 OPA4192