OPA2192 Datasheet, PDF (28/51 Pages) Texas Instruments – OPAx192 36-V, Precision, Rail-to-Rail Input/Output, Low Offset Voltage,Low Input Bias Current Op Amp with e-trim

OPA192, OPA2192, OPA4192
SBOS620D – DECEMBER 2013 – REVISED SEPTEMBER 2015
www.ti.com
8.3.6 Common-Mode Voltage Range
The OPAx192 is a 36-V, true rail-to-rail input operational amplifier with an input common-mode range that
extends 100 mV beyond either supply rail. This wide range is achieved with paralleled complementary N-channel
and P-channel differential input pairs, as shown in Figure 63. The N-channel pair is active for input voltages
close to the positive rail, typically (V+) – 3 V to 100 mV above the positive supply. The P-channel pair is active
for inputs from 100 mV below the negative supply to approximately (V+) – 1.5 V. There is a small transition
region, typically (V+) –3 V to (V+) – 1.5 V in which both input pairs are on. This transition region can vary
modestly with process variation, and within this region PSRR, CMRR, offset voltage, offset drift, noise and THD
performance may be degraded compared to operation outside this region.
+Vsupply
IS1
e-Trim^TM
VIN-
PCH1
VIN+
PCH2 ^NCH3
NCH4
FUSE BANK
VOS TRIM VOS DRIFT TRIM
Figure 63. Rail-to-Rail Input Stage
-Vsupply
To achieve the best performance for two-stage rail-to-rail input amplifiers, avoid the transition region when
possible. The OPAx192 uses a precision trim for both the N-channel and P-channel regions. This technique
enables significantly lower levels of offset than previous-generation devices, causing variance in the transition
region of the input stages to appear exaggerated relative to offset over the full common-mode range, as shown in
Figure 64.
P-Channel
Region
Transition
Region
N-Channel
Region
P-Channel Transition
Region
Region
N-Channel
Region
200
200
100
100
0
0
±100
±200
OPA192 e-Trim
Input Offset Voltage vs Vcm
±300
±15.0 ±14.0
«11.0 12.0 13.0
Common-Mode Voltage (V)
14.0 15.0
±100
±200
Input Offset Voltage vs Vcm
without e-Trim Input
±300
±15.0 ±14.0 «11.0 12.0 13.0
Common-Mode Voltage (V)
14.0 15.0
Figure 64. Common-Mode Transition vs Standard Rail-to-Rail Amplifiers
28
Submit Documentation Feedback
Copyright © 2013–2015, Texas Instruments Incorporated
Product Folder Links: OPA192 OPA2192 OPA4192