English
Language : 

TS3USB221E Datasheet, PDF (3/20 Pages) Texas Instruments – HIGH-SPEED USB 2.0 (480-Mbps) 1:2 MULTIPLEXER/DEMULTIPLEXER SWITCH WITH SINGLE ENABLE AND IEC LEVEL 3 ESD PROTECTION
◁
TS3USB221E
www.ti.com......................................................................................................................................................................................... SCDS263 – SEPTEMBER 2009
ABSOLUTE MAXIMUM RATINGS(1)
over operating free-air temperature range (unless otherwise noted)
VCC
Supply voltage range
VIN
Control input voltage range(2)(3)
VI/O
Switch I/O voltage range(2)(3)(4)
IIK
Control input clamp current
II/OK
I/O port clamp current
II/O
ON-state switch current(5)
Continuous current through VCC or GND
θJA
Package thermal impedance(6)
Tstg
Storage temperature range
VIN < 0
VI/O < 0
DRC package(7)
RSE package
ZXU package
MIN
MAX UNIT
–0.5
4.6
V
–0.5
7
V
–0.5
7
V
–50 mA
–50 mA
±120 mA
±100 mA
48.7
243 °C/W
128
–65
150 °C
(1) Stresses beyond those listed under "absolute maximum ratings" may cause permanent damage to the device. These are stress ratings
only, and functional operation of the device at these or any other conditions beyond those indicated under "recommended operating
conditions" is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
(2) All voltages are with respect to ground, unless otherwise specified.
(3) The input and output voltage ratings may be exceeded if the input and output clamp-current ratings are observed.
(4) VI and VO are used to denote specific conditions for VI/O.
(5) II and IO are used to denote specific conditions for II/O.
(6) The package thermal impedance is calculated in accordance with JESD 51-7.
(7) Package Preview
RECOMMENDED OPERATING CONDITIONS(1)
VCC
Supply voltage
VIH
High-level control input voltage
VIL
Low-level control input voltage
VI/O
Data input/output voltage
TA
Operating free-air temperature
VCC = 2.3 V to 2.7 V
VCC = 2.7 V to 3.6 V
VCC = 2.3 V to 2.7 V
VCC = 2.7 V to 3.6 V
MIN
2.3
0.46 × VCC
0.46 × VCC
0
–40
MAX
3.6
0.25 × VCC
0.25 × VCC
5.5
85
UNIT
V
V
V
V
°C
(1) All unused control inputs of the device must be held at VCC or GND to ensure proper device operation. Refer to the TI application report,
Implications of Slow or Floating CMOS Inputs, literature number SCBA004.
Copyright © 2009, Texas Instruments Incorporated
Submit Documentation Feedback
3
Product Folder Link(s): TS3USB221E
 ▷