THS6052IDDA Datasheet, PDF (3/21 Pages) Texas Instruments – 175 mA, ±12 V ADSL CPE LINE DRIVERS

THS6052, THS6053
175 mA, ±12 V ADSL CPE LINE DRIVERS
SLOS293D − JUNE 2000 − REVISED DECEMBER 2001
electrical characteristics over recommended operating free-air temperature range, T_A = 25°C,
V_CC = ±12 V, R_FEEDBACK = 750 Ω, R_L = 100 Ω (unless otherwise noted)
dynamic performance
PARAMETER
TEST CONDITIONS
VCC = ± 5 V
G= 1, RF = 1 kΩ
VCC = ±12 V
RL = 50 Ω _{G= 2, RF = 680 Ω}
G= 8, RF = 330 Ω
VCC = ±5 V, ±12 V
BW
Small-signal bandwidth (− 3 dB)
VCC = ± 5 V
G= 1, RF = 1 kΩ
VCC = ±12 V
RL = 100 Ω _{G= 2, RF = 680 Ω}
G= 8, RF = 330 Ω
VCC = ±5 V, ±12 V
VCC = ± 5 V
VO = 4 VPP VCC = ±12 V
SR
Slew rate (see Note 2), G=8
VCC = ±15 V
VCC = ±12 V
VO = 16 VPP _{VCC = ±15 V}
NOTE 2: Slew rate is defined from the 25% to the 75% output levels.
VCC = ± 5 V
VCC = ±12 V
VCC = ±15 V
VCC = ±12 V
VCC = ±15 V
noise/distortion performance
PARAMETER
THD
Total harmonic distortion (single-ended
configuration)
Vn
Input voltage noise
TEST CONDITIONS
Gain = 8,
RL = 100 Ω,
VCC = ±12 V, f = 250 kHz
VO(pp) = 2 V
VO(pp) = 16 V
Gain = 8,
RL = 50 Ω,
VCC = ±5 V, f = 250 kHz
VO(pp) = 2 V
VO(pp) = 6 V
VCC = ±5 V, f = 10 kHz ,
±12 V
In
Input current noise
XT
Crosstalk
+Input
−Input
f = 10 kHz,
f = 250 kHz,
G = 2,
f = 250 kHz,
G = 2,
VCC = ±5 V,
VCC = ±12 V,
VCC = ±15 V
VCC = ±12 V,
RL= 100 Ω
VCC = ±5 V,
RL= 50 Ω
VO = 2 Vp-p
VO = 2 Vp-p
MIN TYP MAX UNIT
110
120
100
90
MHz
150
170
135
110
650
850
950
1500
V/µs
1700
MIN TYP MAX UNIT
− 83
− 78
dBc
− 74
− 72
2.1
nV/√Hz
2.7
pA/√Hz
10.7
− 79
dBc
− 71
• POST OFFICE BOX 655303 DALLAS, TEXAS 75265
3