BQ24610 Datasheet, PDF (28/33 Pages) Texas Instruments – Stand-Alone Synchronous Switch-Mode Li-Ion or Li-Polymer Battery Charger with System Power Selector and Low Iq

bq24610
bq24617
SLUS892 – DECEMBER 2009
www.ti.com
tie analog ground to power ground (PowerPAD should tie to analog ground in this case). A star-connection
under PowerPAD is highly recommended.
8. It is critical that the exposed PowerPAD on the backside of the IC package be soldered to the PCB ground.
Ensure that there are sufficient thermal vias directly under the IC, connecting to the ground plane on the
other layers.
9. Decoupling capacitors should be placed next to the IC pins and make trace connection as short as possible.
10. All via size and number should be enough for a given current path.
SW
L1
R1
VBAT
High
VIN
Frequency
Current
BAT
C1
Path
PGND
C2
C3
Figure 22. High Frequency Current Path
Current Direction
RSNS
Current Sensing Direction
To SRP - SRN pin or ACP - ACN pin
Figure 23. Sensing Resistor PCB Layout
Refer to the EVM design (SLUU396) for the recommended component placement with trace and via locations.
For the QFN information, refer to SCBA017 and SLUA271.
28
Submit Documentation Feedback
Product Folder Link(s): bq24610 bq24617
Copyright © 2009, Texas Instruments Incorporated