BQ24153A Datasheet, PDF (20/43 Pages) Texas Instruments – Fully Integrated Switch-Mode One-Cell Li-Ion Charger

bq24153A
bq24156A, bq24158
SLUSAB0 – OCTOBER 2010
www.ti.com
Bad Adaptor Detection/Rejection
At the POR of VBUS, the IC performs the bad adaptor detection by applying a current sink to VBUS. If the VBUS
is higher than V_IN(MIN) for 30ms, the adaptor is good and the charge process begins. Otherwise, if the VBUS
drops below V_IN(MIN), a bad adaptor is detected. Then, the IC disables the current sink, sends a send fault pulse
in FAULT pin and sets the bad adaptor flag (B2 - B0 = 011 for Register 00H). After a delay of T_INT, the IC repeats
the adaptor detection process, as shown in Figure 28 and Figure 29.
Adpator
VBUS
VBUS
I_SHORT
(30 mA)
Adaptor Detection Control
GND
PGND
V_IN
V_IN(MIN)
V_{IN_GOOD}
Deglitch
30ms
V_{IN_POOR}
START
Delay
T_INT
Figure 28. Bad Adaptor Detection Circuit
20
Submit Documentation Feedback
Copyright © 2010, Texas Instruments Incorporated
Product Folder Link(s): bq24153A bq24156A bq24158